Techniques for Natural Gas Physical Properties Definition for Flow Rate and Volume Metering Systems
Journal Title: Energy Engineering and Control Systems - Year 2016, Vol 2, Issue 2
Abstract
The results of researching the techniques for natural gas properties determination for flow rate and volume metering systems are presented in the paper. The necessity of developing techniques for calculating the isentropic exponent of natural gas for pressure up to 25 MPa based on a simplified set of parameters of gas composition is shown. New techniques are proposed to define isentropic exponent and dynamic viscosity based on designed analytical dependence for the calculation the pseudo-critical density of natural gas, regression equation for isentropic exponent and improved equation of Dean and Steal for calculating gas dynamic viscosity for high pressure. Techniques adequacy verification is carried out relative to the arrays of calculated values of adiabatic index and viscosity obtained from high-precise equations of gas state and relative to the experimental data of viscosity and sound speed in natural gas. The techniques errors and the range of their application are defined using the verification results.
Authors and Affiliations
Fedir Matiko, Halyna Matiko, Vitalii Roman, Ivan Stasiuk
Keywords
Related Articles
- EP ID EP256964
- DOI 10.23939/jeecs2016.02.049
- Views 158
- Downloads 0
Temperature Dependence Estimation of the Vibration and Frequency Sensor Resonator Mechanical State
The complex of technological and metrological researches concerning development of filamentous monocrystals application and fixing methods on various materials of substrate (elastic elements) is considered. The ways of u...
Alternative Energy Source for Heating System of Woodworking Enterprise
At woodworking enterprises, there is a large amount of wood waste the energy potential of which can be used as an alternative source of energy for the generation of heat energy at boiler houses. Gasification is one of th...
Analysis of Methods for Extending the Life Cycle of a TP-100A Boiler
Reconditioning of the TP-100А boiler can be implemented via a number of engineering solutions, including a complete replacement of the heating surface of the primary and secondary steam superheating circuits, boiler drum...
Determination of Hydro-Erosion Wear Coefficient for Sealing Elements of Pipeline Fittings
A model of hydro-erosion wear of sealing elements was constructed taking into account a set of parameters that reflect the physical properties of the fluid and the material of the sealing elements, as well as the design...
Dynamic Modelling of Centrifugal Hydraulic Load of Pumping Station Electric Drive
The paper analyzes modern trends in modelling the centrifugal hydraulic load of the pumping station electric drive. It was found that a very simplified approach to the representation of one of the inextricably linked sub...