The comparative studies of ADI versus Hadfield cast steel wear resistance
Journal Title: Archiwum Odlewnictwa - Year 2011, Vol 11, Issue 2
Abstract
The results of comparative studies of wear resistance of ADI versus high manganese Hadfield cast steel are presented. For evaluation of wear resistance three type of ADI were chosen. Two of them were of moderate strength ADI with 800 and 1000MPa tensile strength while the third was 1400MPa tensile strength ADI. The specimens were cut from ADI test YII type casting poured and heat treated in Institute of Foundry in Krakow. The pin on disc method was used for wear resistance experiment. The specimens had a shape of 40mm long rod with diameter 6mm. The load and speed were 100N and 0,54m/s respectively. It was concluded that the wear resistance of ADI is comparable with high manganese cast steel and in case of low tensile grade ADI and is even better for high strength ADI than Hadfield steel.
Authors and Affiliations
P. Skoczylas, A. Krzyńska, M. Kaczorowski
Keywords
Related Articles
- EP ID EP72527
- DOI -
- Views 94
- Downloads 0
Effect of dispersion hardening on impact resistance of EN AC-AlSi12Cu2Fe silumin
Development of modern technology have generated supply of better and better, more resistant structural materials not attainable earlier. Weight of metal structures is of a great importance, and as a consequence, also wei...
Selected aspects of the piece production of iron alloy castings in terms of their environmental impact
Problems of environmental protection are nowadays one of the top priorities in a policy programme adopted by the European Community. Reducing the negative impact of the domestic foundry industry on environment should res...
The influence of the conditions of gypsum plaster preparation on its technological properties
The results of researches on influence of basic preparation parameters, i.e. time and mixing intensity, start and end time of set, dimensional changes and strength of gypsum plaster, are presented in this paper. Determi...
Analysis of the Compounds from the BTEX Group, Emitted During Thermal Decomposition of Alkyd Resin
Suitability of the given binding agent for the moulding sands preparation depends on the one hand on the estimation of technological properties of the sand and the mould made of it and the obtained casting quality and on...
Nitrogen hardening of creep-resistant G-NiCr28W alloy
In the group of creep-resistant materials, most important are heat-resistant nickel-based alloys. The G-NiCr28W alloy subject to detailed examinations was observed to have two different austenite-like phases. In the inte...