THE CONTROL OF INCIPIENT STATE TREATING TOOL WEAR WITH USAGE OF ACOUSTIC EMISSION
Journal Title: Вісник Національного Авіаційного Університету - Year 2017, Vol 71, Issue 2
Abstract
Purpose: The aim of this article is the experimental research of acoustic emission at composite material machining with the analysis of influencing treating tool wear from composite material on registered signals parameters. Methods: In the basis of researches lies the processing and analysis of interconnection experimental acoustic emission signals parameter, which one appear at composite material machining, with treating tool wear. The acoustic emission at initial and final stage of composite material machining are esteemed. The statistical processing of acoustic emission amplitude parameters on these stages was conducted. The statistical data processing with the analysis regularity change of acoustic emission signals amplitudes distribution kurtosis is conducted. Results: Is determined, that the increase of composite material machining time does not result in change of acoustic radiation nature. The registered acoustic emission signals are continuous signals. Is established, that at composite material machining final stage is watched decreasing of acoustic emission signal amplitude average level and value of its deviation. Is determined, that the gradual or instantaneous increase of treating tool wear results in its destruction and sharp decreasing of acoustic emission signal amplitude. The regularity change of acoustic emission signals amplitudes distribution kurtosis at all stages of composite material machining is established. Discussion: The analysis of acoustic emission statistical amplitude parameters change at initial and final stage composite material machining is conducted. Decreasing of acoustic emission statistical amplitude parameters at final stage of machining is shown, that is conditioned by treating tool wear. It is shown, that originating and development of treating tool wearing up to an instant of its damage results in minor decreasing of acoustic emission signal amplitude average level. At the same, at early stage, which one will precede to tool damage, there is a discontinuous of acoustic emission signals amplitudes distribution kurtosis change from stable positive value up to negative value. At the moment of tool disastrous damage the nature of acoustic emission signals amplitudes distribution kurtosis change varies on inverse. Such change of acoustic emission parameters, apparently, is conditioned by originating the processes leading to tool destruction, and, as a consequent, change of treating and treated composite materials conditions interplay. The obtained outcomes have shown that the processing and analysis of regularity of acoustic emission signals amplitudes distribution kurtosis change can be utilized for control of composite materials technological process machining. Thus it is possible to determine and control the moment of processes originating incipient state, which one conduct to destruction of the treating tool.
Authors and Affiliations
Sergii Filonenko, Oleg Zaritskyi
Keywords
Related Articles
- EP ID EP459682
- DOI 10.18372/2306-1472.71.11747
- Views 98
- Downloads 0
A HYBRID APPROACH TO THE OPTIMAL AERONAUTICAL ENGINEERING MAINTENANCE PERIODICITY DETERMINATION
Purpose: The goal of this research is to investigate the possibility of the objectively existing aeronautical engineering maintenance optimal periodicity determination in the different from the entirely probabilistic met...
VORTEX FLOW WINGS
The paper presents an analysis of two alternative methods of influence on integral aerodynamic characteristics at large angles of attack with global flow separation. Firstly, the approach related to flat l...
INFLUENCE OF TRANSMITTER NONLINEARITIES ON DATA TRANSMISSION FROM REMOTELY PILOTED AIR SYSTEM
Purpose: 1) to develop a model of a communication channel of an unmanned aerial vehicle "UAV-Ground station" with adaptive modulation and orthogonal frequency division of channels; 2) to calculate the channel parameters...
DESIGN OF ROBUST NAVIGATION AND STABILIZATION LOOPS OF PRECISION ATTITUDE AND HEADING REFERENCE SYSTEM
Purpose: The paper focuses on problems of design of robust precision attitude and heading reference systems, which can be applied in navigation of marine vehicles. The main goal is to create the optimization procedures f...
TRENDS IN THE DEVELOPMENT OF THE AVIATION VOCABULARY
The article considers modern trends in the development of the terminology of the aviation industry, which were formed under the influence of linguistic and non-linguistic mechanisms. The purpose is to id...