THE DESIGN OF THE AUTOMATIC DOOR CONTROL SYSTEM
Journal Title: Topics in Intelligent Computing and Industry Design (ICID) - Year 2017, Vol 1, Issue 2
Abstract
This design is based on single-chip microcomputer for auto-door control system, mainly by the master and the human infrared induction parts, motor parts, clock, display segments consists of five parts. PIR sensor acquisition by being able to identify the human body the human body signals, then sends the signal to the AT89C52 MCU processing. After SCM process, on the one hand the motor driver IC L289 control trigger signals, thereby by the motor driver IC motor control forward and reverse, and when he opens the door, reverse the door when closed, so as to realize the opposite control; Alarm devices, display control on the other hand, when an alarm signal is triggered, sound and light alarm, and display of date and time on the display in order to achieve functional purpose
Authors and Affiliations
Biqing Li, Zhao Li, Xiuru Tan
Keywords
Related Articles
- EP ID EP409338
- DOI 10.26480/icie.01.2017.87.90
- Views 45
- Downloads 0
DAMPING LAYER OPTIMIZATION DESIGN OF VISCOELASTIC CO-CURING STRUCTURE
In order to improve the dynamic environment of new weapons, viscoelastic co-curing composite is widely used. The damping layer optimization of co-curing structure is the key problem to structure design. First, by compari...
DESIGN AND SIMULATION OF ELECTRONIC CALENDAR BASED ON 51 SINGLE CHIP MICROCOMPUTER
This design use the microcontroller design electronic calendar needs of a careful analysis, and then designed the hardware part of the circuit diagram, the use of Keil software to write the required procedures, and final...
STRAIN ANALYSIS OF CRACKED SHAFT BASED ON ELECTRIC MEASUREMENT THEORY
The electrical measurement method is adopted. The cracked shaft is regarded as a beam. In case of static force and the cracked shaft rotating 360 degrees, strain at a point near the crack is studied. The effect of crack...
CHANGES IN THE STRUCTURE AND PHYSICAL PROPERTIES OF HEAT-TREATED COBALT-BASED BIOMATERIAL
The paper describes cast cobalt alloy after thermal processing – recrystallizing annealing in 1173 ÷ 1473 K temperature range. The aim of processing was to decrease the percentage of the dendritic structure and obtain cr...
DESIGN OF THE DOUBLE-LOOP NETWORKED CONTROL SYSTEM WITH DIFFERENT SAMPLING RATE BASED ON SMITH PREDICTOR
The double-loop networked control system with different sampling rate is investigated in this paper. In order to overcome the effect of network-induced time delay, the design methods based on conventional Smith predictor...