THE EFFECT OF CHANGES IN DEPTH OF CUT ON SURFACE ROUGHNESS IN MACHINING OF AISI 316 STAINLESS STEEL
Journal Title: Journal of Machine Engineering - Year 2018, Vol 18, Issue 1
Abstract
Currently, process optimization is an important part of design of CNC toolpath, allowing overall process improvement in accordance to a range of criteria. Available CAE software for CNC toolpath optimization works only by changing the feed rate value specified in the base toolpath. The authors are planning to devise a solution allowing for optimization of other process parameters, including depth of cut. In some cases, it would be important for surface roughness to remain unaltered after optimization by means of increasing depth of cut. In this work, the effect of depth of cut on surface roughness was investigated. Depth of cut was altered for the roughing pass, while technological parameters for the finish pass remained constant. Roughness measurements were performed on-machine after rough turning and finish turning. The authors have found that depth of cut has a noticeable effect on investigated roughness parameters, both in the case of rough turning and subsequent finish turning operations.
Authors and Affiliations
Krzysztof JAROSZ, Piotr LÖSCHNER
Keywords
Related Articles
- EP ID EP269971
- DOI 10.5604/01.3001.0010.8824
- Views 77
- Downloads 0
EFFICIENT QUANTIFICATION OF FREE AND FORCED CONVECTION VIA THE DECOUPLING OF THERMO-MECHANICAL AND THERMO-FLUIDIC SIMULATIONS OF MACHINE TOOLS
Thermo-elastic deformations represent one of the main reasons for positioning errors in machine tools. Investigations of the thermo-mechanical behaviour of machine tools, especially during the design phase, rely mainly o...
END MILLING OF TI-48AL-2CR-2NB UNDER HIGH-FEED CONDITIONS
Gamma titanium aluminides are fast developing materials and particularly in use for aerospace and automotive components. Due to the high cutting forces and raised cutting temperatures achieved during milling of this mate...
UTILISATION OF IOT AND SENSING FOR MACHINE TOOLS
Strong requirements for automation in the production processes using machine tools have been increasing due to lack of high-skilled machining engineers. Automation used to be utilised in mass production, but it is also n...
INFLUENCE OF LINEAR FEED DRIVE CONTROLLER SETTING IN CNC TURNING LATHE ON THE STABILITY OF MACHINING
The paper deals with the influence of linear feed drive controller setting of a CNC turning lathe on the stability of machining. A coupled simulation model of feed drive control and ball screw drive mechanics with a tra...
COMPLEMENTING AND ENHANCING DEFINITIONS OF LINE PROFILE COMPOSITE TOLERANCE IMPOSED BY ISO GEOMETRICAL PRODUCT SPECIFICATION
According to the ISO Geometrical Product Specifications (GPS), if two or more specifications of the same characteristic are to be indicated, they may be combined as a composite tolerance. Therefore there are no definitio...