The Effect of Organic Polymer Interfacial Layer Thickness and Series Resistance C-G/-V Characteristics in Al/PVA (Zn-doped)/p-Si (MPS) Structure
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2018, Vol 6, Issue 3
Abstract
In this study, the electrical properties of polymer interfacial layer Al/p-Si (MPS) with thickness of 50 and 150 nm (Zn-doped PVA) were investigated in terms of frequency using the capacitance- conductance-voltage (C-G/-V) measurement methods. C-G/-V measurements were taken at room temperature at frequencies of 2kHz, 20kHz and 200kHz in the range of -3.5 / + 5.5 V with 50 mV steps. Utilizing the cut-off point and slope of the linear part of the reverse biased C-2-V graphics; basic electrical parameters such as the values of diffusion potential (VD), doping concentration of acceptor atoms (NA), Fermi energy level (EF), depletion layer width (WD) and barrier height (ΦB) were obtained and compared based on both frequency and thickness. These parameters are highly dependent on both the thickness of organic interface layer and frequency. In addition, voltage-dependent change profiles of interface states (Nss) and the resistance (Ri) were obtained using low-high frequency (CLF-CHF) capacitance method and the Nicollian and Brews method of these structures using, respectively. To determine which region and frequency of the series resistance (Rs) effect is more effective, measured C-G/-V curves were corrected considering Rs value. Obtained experimental results were observed to be very effective on the C-G/-V of the polymer interfacial layer thickness and Rs and Nss values.
Authors and Affiliations
Hüseyin TECİMER
Keywords
Related Articles
- EP ID EP491139
- DOI 10.29109/gujsc. 404801
- Views 71
- Downloads 0
Comparison of Axial Flux PMSM and Outrunner PMSM under Same Physical and Electrical Parameters according to Cogging Torque
Axial flux permanent magnet motor (AFPMM) and outrunner permanent magnet motor (ORPMM) are generic rotating machines that are commonly used. Cogging torque is an undesired output for electrical motors. Although the coggi...
Investigation of Optimum Intermediate Pressure in Two-Stage Critical Overhead CO2 Cycle Cooling Systems
In this study, the variation of optimal inter-stage pressure of two stage transcritical CO2 cooling cycle with evaporating temperature and gas cooler outlet temperature of CO2 is theoretically studied. However optimum ga...
The Investigation of Thermal Conductivity Coefficients of H3BO3/PP Composites
In this study, it is aimed to provide additional contributions to insulating and energy savings by lowering the thermal conductivity values of the polypropylene used in areas where especially the insulating properties ar...
The Effect of Organic Polymer Interfacial Layer Thickness and Series Resistance C-G/-V Characteristics in Al/PVA (Zn-doped)/p-Si (MPS) Structure
In this study, the electrical properties of polymer interfacial layer Al/p-Si (MPS) with thickness of 50 and 150 nm (Zn-doped PVA) were investigated in terms of frequency using the capacitance- conductance-voltage (C-G/...
The Effects of Shallow Cryogenic Process On The Mechanical Properties of AISI 4140 Steel
In this study, shallow cryogenic treatments were carried out for various holding time to AISI 4140 steel and the effects of heat treatment parameters on wear behavior, impact strength and tensile strength were investigat...