THE HEIGHT SURVEY OF MOUNT ŁYSICA IN THE CONTEXT OF VERIFICATION OF GEODESICAL AND CARTOGRAPHIC STUDIES
Journal Title: Structure and Environment - Year 2019, Vol 11, Issue 2
Abstract
The subject of the article is the measurements of normal height (H) of the western top of Mount Łysica (Świętokrzyskie Mountains, Poland), carried out using the GNSS and geometric leveling methods according to standards for geodetic control network. As the elevation system EN-KRON86-NH was assumed. The reference data was the result of earlier measurements made using different methods: ALS, GNSS RTN and geometric levelling between selected points of Mount Łysica. The analysis of the survey results showed differences between the DEM from ALS measurement and the actual height reaching up to 0.47 m on small boulders and not exceeding the value of 0.17 m in the flat area. Differences between GNSS RTN measurement and geometric leveling based on GNSS static easurement did not exceed 0.03 m. An inventory of former state geodetic control network point “12 Góra Łysica” was also conducted. The point was found to be partially destroyed, and located 12 m south and 1.5 m below the actual top of the mountain. Therefore it was assumed, that a new geodetic control network point
Authors and Affiliations
Ihor Romanyshyn, Maciej Hajdukiewicz
Keywords
Related Articles
- EP ID EP626606
- DOI 10.30540/sae-2019-012
- Views 94
- Downloads 0
FATIGUE LIFE COMPARISON OF RECYCLED COLD MIXES WITH DIFERENT TYPE OF BITUMEN BINDER
loading cycles. The possibility of using foamed bitumen and bitumen emulsion as binders in the composition of road bases makes it necessary to identify the influence of the binder type on the service life of these layers...
THE TEMPERATURE DISTRIBUTION OF THE MATERIALS IN THE CONVECTIVE HEAT TRANSFER
A new method for solving the equations of thermal conductivity materials with specific properties. This method is useful for an approximate estimate of the temperature field of materials.
IMPACT OF SUPPORT CLOSED SECTION RIBS ON THE CRITICAL MOMENT FOR LATERAL TORSIONAL BUCKLING OF STEEL BEAMS
The study presents the results of theoretical investigations into the effect produced by support closed section ribs on the critical moment for lateral torsional buckling (Mcr) of bisymmetric I-beams. Elastic restraint a...
THE ENVIRONMENTAL ASSESSMENT OF MECHANICAL-BIOLOGICAL WASTE TREATMENT BY LCA METHOD
The computer program IWM-PL for the life cycle assessment (LCA) of waste was described. The environmental impact of the mechanical-biological treatment (MBT) technology was estimated. Final report shows that the analysed...
THE INFLUENCE OF PARTICULAR PARAMETERS ON THE TEMPERATURE DISTRIBUTION IN THE IMPLETION OF REGENERATIVE HEAT EXCHANGER
The article describes the process of unsteady heat transfer that occurs between the impletion of regenerative heat exchanger and the surrounding air. A mathematical model of this phenomenon and its exemplary solution usi...