The impact of visiting hours on indoor to outdoor ratio of fungi concentration at Golestan Hospital in Ahvaz, Iran
Journal Title: Journal of Advances in Environmental Health Research (JAEHR) - Year 2016, Vol 4, Issue 1
Abstract
The majority of diseases caused by air pollution, such as asthma and allergies, are caused by pathogenic bacteria, which are transmitted through bioaerosols. Bacteria and fungi are the main sources of hospital infections causing the majority of diseases and cases of mortality. The aim of this study was to determine the ratio of indoor to outdoor fungi concentration, the effect of population density on fungi concentration, and the relationship between indoor and outdoor environments. In this study, 3 stations were assessed; the outdoor environment, general indoor environment, and intensive care units (ICUs) of a hospital affiliated to Ahvaz University of Medical Sciences, Iran. These stations were used for the sampling of airborne fungi from October to December 2010. The samples were collected over a period of 2 minutes in a flow rate of 28.3 l/minute using a QuickTake 30 air sampling pump. The 3 dominant fungi genera in the sampling stations were Aspergillus, Penicillium, and Cladosporium. The average of total fungi concentration before visiting hours was 365.8 CFU/m which was reduced to 578 CFU/m after visiting hours. The indoor to outdoor ratios in the ICU and internal wards for fungi before visiting hours were 0.36 and 0.68, respectively. However, these ratios in the ICU and internal wards for fungi after visiting hours were 0.78 and 0.99, respectively. Following the visiting hours, the concentration of fungi available indoors was conspicuously higher (even in the wards in which no visitors were allowed (e.g., ICUs). Hence, the amount of indoor fungi was affected by the concentration of outdoor fungi and the number of visitors.
Authors and Affiliations
Yusef Omidi-Khaniabadi, Ali Jafari, Mehdi Jourvand, Sedigheh Saeedi, Hassan Basiri, Heshmatollah Nourmoradi, Gholamreza Goudarzi, Seyed Mohammad Daryanoosh, Bahram Kamarehei, Shahram Sadeghi, Mohammad Javad Mohammadi
Keywords
Related Articles
- EP ID EP423857
- DOI 10.22102/jaehr.2016.40213
- Views 151
- Downloads 0
Determining suitable model for zoning drinking water distribution network based on corrosion potential in Sanandaj City, Iran
Corrosion in general is a complex interaction between water and metal surfaces and materials in which the water is stored or transported. Water quality monitoring in terms of corrosion and scaling is crucial, and a key e...
Simultaneous degradation and adsorption of cyanide using modified fly Ash and TiO2/UV
Due to the present water shortage and environmental problems associated with industrial effluent, investigation of novel treatment technologies is an essential approach. Being a highly toxic chemical of asphyxiating char...
Modeling of CO dispersion from the stack of an Iranian cement Plant
The objective of our study was to simulation of carbon monoxide (CO) dispersion exited from the stacks of a cement industry of Doroud, Iran by Gaussian Model (GM). Four sampling period was conducted to measurement of CO...
Assessment of dental waste production rate and management in Sari, Iran
Dental offices produce a variety of dangerous wastes during normal business day. Most of these waste are non-hazardous that can be managed as household wastes; however, some component are hazardous and can pose a risk to...
Adsorption of 4-chlorophenol from aqueous solution using activated carbon synthesized from aloe vera green wastes
In this study, activated carbon synthesized from Aloe vera green wastes was used as a sorbent to remove 4-chlorophenol (4-CP) from aqueous solutions. The influence of contact time (0-100 minutes), pH (2-8), adsorbent dos...