THE MICROSTRUCTURAL PROPERTIES OF PLASTER COMPOSITE PRODUCED DURING PRE-REPUBLIC AND EARLY REPUBLIC PERIODS IN DEMIRCI
Journal Title: INTERNATIONAL JOURNAL OF ENGINEERING TECHNOLOGIES AND MANAGEMENT RESEARCH - Year 2017, Vol 4, Issue 12
Abstract
Structural plaster properties of the residence type buildings that were constructed during prerepublic and early republic periods in Demirci were investigated within the scope of this study. Samples taken from the existing structures were dried in laboratory conditions and made ready for micro-structure examination. Proper samples were examined with scanning electron microscopy (SEM) with the sensitivity of 5 nm and a magnification of 20.000 times, and the optical microscope (magnification: 250 x). In the light of obtained results, it has been determined that the microstructure of the composite used in the Demirci county in the preRepublican period and early republic period is similar to the resultant of mixes produced with the modern fiber added composite production technology. It is thought that this study will contribute to the study of the production of the related building materials to be improved in the future within the limits of the district.
Authors and Affiliations
Keywords
Related Articles
- EP ID EP261478
- DOI 10.5281/zenodo.1133175
- Views 111
- Downloads 0
A CRITICAL LITERATURE REVIEW ON IMPROVING PROJECT COST MANAGEMENT PRACTICE AND PROFITABILITY OF DOMESTIC CONTRACTORS
Construction cost management is the most important function for project success, and the construction project performance is generally expressed in terms of cost and its variance from the budget. However, it has not been...
INTEGRATION OF BUILDING INFORMATION MODELLING (BIM) AND INDUSTRIALIZED BUILDING SYSTEM (IBS)
The Construction industry in Malaysia is always progressively moved ahead with the full support from the Malaysian government through the Construction Industry Development Board (CIDB). As report by CIDB, “there were 34,...
ASSESSMENT AND FACTORS OF RISK IN AN IPO’S
In present scenario IPO’s are the best way of investment for the good returns as well. These IPO’s totally depends on market. Investment in IPO’s may contain risk factor and may be harmful in terms of loss. So, in this p...
DESIGN AND SIMULATION OF AUTOMATIC POWER FACTOR CORRECTION FOR INDUSTRY APPLICATION
In the present technological revolution power is very precious. So we need to find out the causes of power loss and improve the power system. Due to industrialization the use of inductive load increases and hence power s...
SIMULATION & PERFORMANCE OF THREE PHASE HALF CONTROLLED CONVERTER WITH D.C. MOTOR
This paper presents performance result of single and three phase rectifier circuits using MATLAB-SIMULINK which are one of the most used power electronics circuit. This paper also describes method & concepts used to simu...