THE MULTI-RESPONSE OPTIMIZATION OF MACHINING PARAMETERS IN THE ULTRASONIC ASSISTED DEEP-HOLE DRILLING USING GREY-BASED TAGUCHI METHOD
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2018, Vol 8, Issue 4
Abstract
This paper presents a practical approach for the multiple response optimizations of operational parameters in the ultrasonic assisted drilling of deep holes. Applying the Taguchi design of experiments, a plan of 27 drilling tests on 6061 aluminium alloy with the depth-to-diameter ratio of 10 was conducted. The responses of cutting force and torque, maximum force and torque, including the chip-evacuation parts which appeared when drilling deep holes, were chosen to be optimized. Three significant drilling parameters, named vibration amplitude, feeding rate and cutting speed were found to have the most significant effects on the output responses. Based on the grey relational grade analysis and analysis of variance technique, optimum levels as well as the percentage contribution of such parameters were identified. Confirmation test was conducted to validate the test result. Experimental results showed that the multi-response optimization problem in ultrasonic assisted the deep hole drilling can be effectively addressed through the combination of Taguchi design and Grey relational analysis.
Authors and Affiliations
NGOC HUNG CHU, VAN DU NGUYEN
Keywords
Related Articles
- EP ID EP430511
- DOI 10.24247/ijmperdoct201847
- Views 81
- Downloads 0
Optimisation of Process Parameters in Water Jet Peening on AA6063 Aluminium Alloy by Response Surface Methodology
Water Jet Peening (WJP) is a modern non-traditional surface treatment process which is used to improve the surface integrity of a material. In this study Aluminium Alloy (AA 6063) is subjected to Water jet peening surfac...
Experimental Study on a Spark Ignitio Engine Fuelled with Petrol and N-Butanol Blends
An Experimental study was carried out on a Twin cylinder, Car-Spark Ignition Engine with MPFI fuel system, then the Engine Runs at the constant speed of 2500rpm for all loads, Fuelled with petrol and n-Butanol blends at...
Prediction of Natural Frequencies of Thick Circular Plates using Finite Element Analysis
This paper presents linear free vibration of thick isotropic circular plates using finite element simulation. The three-dimensional ‘SOLID185’ element of ANSYS is used to calculate the natural frequencies of uniform circ...
Friction Surfacing of Stainless Steel on Low Carbon Steel for Corrosion Resistance Application-An Experimental Approach
The friction surfacing is one of the friction welding processes, used for deposition of desired material on substrate. These deposits being of solid phase bonding, no external heat source is required and it is very much...
Shear Stress Analysis in Palm Kernel Shell Reinforced Brake Linings
The load applied to the pad during breaking to slow the moving vehicle tends to cause shear in the pad material as it rubs on the disc surface. Depending on the nature and composition of the pad material, the load applic...