The Performance Evaluation of Injector using Numerical Technique
Journal Title: International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ) - Year 2019, Vol 9, Issue 4
Abstract
In this study, the aeronautical and aerospace standard rocket injector have been analyzed with different aerodynamic parameters in order to understand the performance of the injectors in different atmospheric conditions. These injectors are the primary device to inject the fuel form the manifold to the ignition chamber. It creates the requited pressure, mass flow rate and the flow velocity in order to generate atomization of the fuel molecule. This atomization of the micro fuel droplet create fuel spray angle, which indeed produce high fuel burn rate. The injector with improper design may cause, unburnt fuel molecule, which will turn to carbon deposit inside the mixture chamber and gets corroded. In this paper the author has investigated the injector flow rate with respect to the injector throat area. The fuel used in this cold flow test study is commercial kerosene. The result indicates that, as the pressure at the inlet increases, the spray cone angle, mass flow rate and flow velocity also increases gradually. This numerical analysis where performed for various injector throat area with respect to various pressure rate from 20-100 psi. The best injector with all aerodynamic properties have been selected. This research paper will be benefit for the researchers and aeronautical industries, which help them to study the different aerodynamic parameter change in various injector throat area.
Authors and Affiliations
J. K. Ajay Kumar, Sriniva G
The CFD Analysis of Subsonic Flow Around Struts of Airfoil and Cylindrical Shape Attached to a Conical Diffuser at Exhaust of a Gas Turbine Engine
After burners are employed in an aero engine of a fighter aircrafts, to achieve maximum thrust during takeoff, climb and during some special combat maneuvers. Since the fuel consumption is high during the afterburning op...
Experimental Investigation of a Combined Solar Parabolic Dish and Trough Collector for Wax Melting Application
The increased cost of electrical energy which depletes conventional resources promotes switching over to renewable solar technology. An experimental study of a simple parabolic dish and trough solar collector combination...
Influence of Tool Pin Geometry on Friction Stir Welded 597 Dissimilar Aluminium Alloys - (AA5083 & AA6061
The present examination focuses on the evaluation of process parameters on mechanical properties and microstructure study of Friction stir welded (FSW) unlike Aluminum alloys. Their extent of use is in naval and marine a...
AN INVESTIGATION OF OPTICAL QUALITIES OF NICKEL OXIDE THIN FILMS DOPED WITH GOLD NANOPARTICLES BY THERMAL EVAPORATION PROCESS
NiO thin films doped with three distinct convergences of Au nanoparticles (AuNPs) are stored on the glass slide substrates at 440oC by thermal evaporation strategy. The impact of AuNPs on the optical properties of NiO th...
COMPARISION OF LIFITING RE-ENTRY AND BALLISITC RE-ENTRY
This paper highlights comparison of lifting re-entry and ballistic re-entry. 3-D. O. F code is developed and used for comparing the different re-entries. The main objective of this paper is to minimize deceleration on re...