The Study of Rotational and Traversal Speeds Effect on Mechanical Properties Of 7075 Aluminium Alloy Friction Stir Welding
Journal Title: International Journal for Research in Applied Science and Engineering Technology (IJRASET) - Year 2017, Vol 5, Issue 5
Abstract
FSW has been successfully used to weld similar and dissimilar cast and wrought aluminium alloys, especially for aircraft aluminium alloys generally present low weldability by traditional fusion welding process. In this article, effects of rotational and traversal speeds on the microstructure and mechanical properties of friction stir-welded 7075-T6 Al alloys were investigated. Good correlation existed between the rotational and traversal speeds and weld properties. It was found that with increase in the rotational and traversal speed, wider thickness of the heat-affected zone were obtained, and then grain coarsening, dissolution, and accumulation of hardening precipitates in grain boundaries. In addition, the highest toughness during tensile test was obtained at moderate rotational and traversal speeds of 325 r/min and 30 mm/min. However, the highest micro hardness was obtained at moderate rotational and traversal speeds of 325 r/min and 60 mm/min. It was imposed high temperature which cause of this different.
Authors and Affiliations
R. Karimdadash
Keywords
Related Articles
- EP ID EP24383
- DOI -
- Views 237
- Downloads 11
Sleep Apnea Syndrome Detection Techniques Using ECG Signal Recordings – A Survey Approach
A type of sleep disorder or syndrome which is characterized by the breaks in respiratory breathing process or occurrences of uncommon or superficial breathing during sleep is called sleep apnea disorder. Since for the l...
Design and Analysis of Leaf Spring Using Composite Materials
This project describes design and experimental analysis of composite leaf spring made of glass fiber reinforced polymer. The objective is to compare the load carrying capacity, stiffness and weight savings of composite...
Soft-Switching Design of Isolated Boost Converter with Coupled Inductor
In this paper the soft-switching design of isolated boost converter is analysed. the participation of resonance in the voltage doubler circuit, clamping capacitor and the reactance leakage in the coupled inductor. By ch...
Design of Press Machine with Automatic Workpiece Ejection System
Press working may be defined as a chip less manufacturing process by which various components are manufactured from sheet metal. This process is also termed as cold stamping. The ram is equipped with a suitable punch an...
Implementation of Polar Codes in 5g
A new proposed method for constructing codes that achieves the symmetric capacity, (the capacity of the channel with the same probabilities for the inputs), I (W) , of any Binary Discrete Memoryless Channel W (BDMC) and...