THE SYSTEM OF DYNAMIC RADIOMONITORING OF THE ENVIRONMENTAL PARAMETERS
Journal Title: Вісник Національного університету "Львівська політехніка", серія "Радіоелектроніка та телекомунікації" - Year 2014, Vol 796, Issue 2014
Abstract
The environmental monitoring systems that display the obtained results on a dedicated site in the Internet are considered. The most common systems consist of one or more measuring devices that form the measuring system located in a controlled stationary object. Such objects can be large settlements and ecologically dangerous enterprises. Each measuring device generates data about the coordinates of it’s location (longitude, latitude) and the levels of controlled environmental parameters. Measuring devices transmit preformed information through the main communication channel to the center of data collection and processing. However, the known system monitors only a few fixed points, which may be not enough within the state. There may be cases when the fixed points of the environmental parameters will not exceed the permissible limits but between them the situation could be alarming. Therefore it’s necessary to create a system of dynamic radiomonitoring of the environmental parameters with increased informativeness about points carrying radiomonitoring by ensuring that the system can function not only with stationary measuring devices but also mobile. As a result, there are two problems: a significant increasing of the workload of the wireless communication channel and the increasing amount and complexity of the results of processing in order to reflect them on a dedicated website. Thus it’s necessary significant system improvements. For significantly reduction of the wireless channel’s workload the sequential preprocessing of measurement results in mobile measuring devices is proposed. If some196 parameters (latitude, longitude and measured parameter) for two consecutive measurements differ slightly, that is within acceptable limits, only label is transmitted that indicates the parameters’ immutability. Then in the data centre according to the brief supplied label the restoration of primary needable to displaying information is done. This dramatically change the amount of information about the results of measurements at a certain time from each of the measuring devices. This system construction requires a single complication of each measuring device, which in general leads to a permanent reduction of the workload of the wireless communication channel. In order to reduce the complexity of processing all the results to display them on a dedicated website offered a replacement logic operations graphical construction. The fact is that for results displaying it’s needable to check each of them for exceeding or not exceeding the permissible level. This test requires the use of logical operations that are quite time consuming, so require certain time costs. Therefore, an important issue is the reduction of the indicated time costs. For the above stated purpose in the data center the advanced data processing is using, which consists in replacing the logic checks by graphical constructions. This construction is based on the use of the proposed method “2D-3D-2D/”.
Authors and Affiliations
Bohdan Strykhalyuk, Volodymyr Pelishok
Keywords
Related Articles
- EP ID EP459738
- DOI -
- Views 138
- Downloads 0
MODEL OF DOWNLINK PREVENTIVE TRANSFER RESTRICTIONS FOR WIMAX TECHNOLOGY IN THE OVERLOAD STATE
Paper depicts that one of the main challenges in wireless networks WiMAX is the task of ensuring the required service quality, which involves the separation of user stations network of guaranteed rate in the downlink. Pr...
EXCITATION OF BULK ACOUSTIC WAVES BY INTERDIGITAL TRANSDUCER FROM THE SURFACE OF LITHIUM NIOBATE CRYSTALS
The excitation of bulk acoustic waves of the UHF range by interdigital transducer from the XY surface of lithium niobate crystals is considered. Experimental studies were carried out on acoustoelectronic delay lines, in...
DYNAMIC MICROOBJECTS PARAMETERS MEASUREMENT RESULTS DISPLAY WITH THE TELEVISION SCANNING OPTICAL MICROSCOPE
Television scanning optical microscope (TSOM) combined with computer support allows control of its modes in general, individual nodes, image processing and transmission capabilities, storage and playback of the data in t...
DEVELOPMENT THE PROCESS OPTIMIZATION METHOD OF MANUFACTURING THE RADIO-ELECTRONIC EQUIPMENT WITH USING OPTIMIZATION PARETO-REGIONS
At the department of theoretical radioengineering and radiomeasurements of Lviv Polytechnic National university the theory and methods of modeling and a process optimization the quality assurance processes of the radio-e...
LINEARY MAX-PLUS MODELS APPLYNG IN TRAFFIC MANAGEMENT TASKS
Development of next generation networks concept let to reconfigure the most of existing traffic controls at telecommunication node. Necessity of its modification causes of low efficient network resources usage. Among of...