The Use of Optical Methods in the Analysis of the Areas with Stress Concentration

Journal Title: Strojnicky casopis - Journal of Mechanical Engineering - Year 2018, Vol 68, Issue 2

Abstract

Anchoring parts of technical systems are often damaged due to the heavy forces acting on these systems during their operation. For that reason, various modifications are suggested and created on the anchoring screws, which should help to reduce the mechanical stress values in a place of the first load-bearing thread of a female screw. For the determination of stress fields on the surface of a plane model of a threaded joint, two non-contact optical methods were used – conventional transmission photoelasticimetry and modern digital image correlation.

Authors and Affiliations

Miroslav Pástor, Peter Frankovský, Martin Hagara and Pavol Lengvarský

Keywords

Related Articles

Determination of Tungsten Inert Gas Welding Input Parameters to Attain Maximum Tensile Strength of 316L Austenitic Stainless Steel

Weld quality mainly depends on the weld bead geometry and mechanical-metallurgical characteristics of the welded joint which has a direct relationship with the type of welding process being used and its input process p...

Detection and Modeling Vibrational Behavior of a Gas Turbine Based on Dynamic Neural Networks Approach

During the gas turbine exploitation the presence of small defects can cause very high vibration amplifications, localized on the components of this rotating machine. For this, a diagnostic process is necessary for deci...

Thermal Characteristics of High Temperature Naturally Circulating Helium Cooling Loop

The paper deals with the process properties in terms of the heat transfer, i.e. the thermal performance of the thermal-process units within a helium loop intended for the testing of the decay heat removal (DHR) from th...

Studies on Improvement of Performance of Compression Ignition Engine Fuelled with Mixture of Honge Biodiesel and Tire Pyrolysis Oil

The biodiesel has lower volatility and is costlier than the fossil diesel. Hence it is necessary to add a low cost fuel which has higher volatility, with the diesel. The tire pyrolysis oil (TPO) produced from waste tire...

Internal Combustion Engine Powered by Synthesis Gas from Pyrolysed Plastics

The article discusses the application of synthesis gas from pyrolysis of plastics in petrol engine. The appropriate experimental measurements were performed on a combustion engine LGW 702 designated for micro-cogenerat...

Download PDF file
  • EP ID EP43940
  • DOI https://doi.org/10.2478/scjme-2018-0018
  • Views 185
  • Downloads 0

How To Cite

Miroslav Pástor, Peter Frankovský, Martin Hagara and Pavol Lengvarský (2018). The Use of Optical Methods in the Analysis of the Areas with Stress Concentration. Strojnicky casopis - Journal of Mechanical Engineering, 68(2), -. https://europub.co.uk/articles/-A-43940