Theoretical foundations for the development of experimental equipment for determining the load capacity of speed change devices
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2018, Vol 4, Issue 1
Abstract
The article gives the theoretical base for construction of equipment for experimental research of static, kinematic and dynamic characteristics of devices for speed change by epicyclic gear trains with closed circuit hydrosystems through the ring gear during the transmission by them of the periodic, shock long-term or short-term loads or their executive mechanism stoppage due to overload. This equipment can be successfully used for experimental study of devices for speed change by epicyclic gear trains with closed circuit hydrosystems through the carriers or sun gears.
Authors and Affiliations
Volodymyr Malashchenko, Oleh Strilets
Keywords
Related Articles
- EP ID EP498251
- DOI 10.23939/ujmems2018.01.125
- Views 120
- Downloads 0
Electromechanical Model of Machine for Vibroabrasive Treatment of Machine Parts
A lot of operations on trimming clean and finishing – stripping up treatment, first of all, removing of burrs, rounding and processing of borders, until recently time was carried out by hand, and hardly exposed to automa...
The influence of the vehicle’s suspension malfunction on its operational efficiency
The main malfunctions that arise when operating a vehicle in Ukraine are the failure of the suspension elements and vehicle tires due to the poor condition of the most roads [11]. The car suspension elements soften the d...
Robust Mechanical Systems with Mechatronic Devices: Parameters Identification and Vibration Control
The disturbance estimated with the help of advanced mechatronic devices is used for realization of robust mechanical system, such as agricultural machines. In the actual application, the estimated disturbance is effectiv...
Determination of Stresses and Ultimate Loads for Composite Plates with Elastic Inclusions
In the article, the algorithm for determination of stresses in anisotropic plates with elastic inclusions of another anisotropic material was developed on the basis of complex singular integral equations. The solving of...
Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel
It is shown that under the influence of alloying (Cr, Mn, C, Si, Ti, N, V) during electric arc hardfacing with a flux cored wire, as well as technological tempering parameters at temperatures of 300...700°C, the phase-st...