THEORETICAL JUSTIFICATION OF CONDITIONS OF CUTTING TEMPERATURE REDUCTION AT GRINDING OF MATERIALS
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2018, Vol 41, Issue 3
Abstract
This research used an adiabatic rods model to conditionally represent the removable allowance and which are cut by a wheel during the grinding process. Numerical calculations were used to establish that the heating time of an adiabatic rod can be up to 10 times shorter than the time of its contact with the grinding wheel during grinding. This is due to the fact that the heating time of the adiabatic rod increases asymptotically with the course of machining time approaching a maximum value determined by the condition of thermal saturation of the surface layer of the work piece. Calculations have established that the cutting temperature and the depth of heat penetration change under the same law. This implies that a large fraction of heat generated during grinding is transferred to the formed chips, and a smaller heat fraction is transferred to the work piece. Based on this, the formulated equations for determining the maximum values for the adiabatic rod heating time, the depth of heat penetration into the surface layer of the work piece, and the cutting temperature during grinding are obtained. It is found that the maximum cutting temperature during grinding is determined only by the conventional cutting stress and does not depend on the grinding mode parameters and grinding wheel characteristics. It is shown that accounting for the adiabatic rod cutting with the grinding wheel reduces the cutting temperature by more than two times, which brings together the theory and practice of grinding. This makes it possible to provide a new approach for the selection of the abrasive wheel contact time and, accordingly, the grinding mode parameters and grinding wheel characteristics, based on the cutting temperature limits. It is also found that the length of the cut section of the adiabatic rod (equal to the grinding depth) is always greater than the depth heat penetration into the work piece, and the cutting temperature is determined by the length of the adiabatic rod subjected to heat, including its cut-off part.
Authors and Affiliations
N. S. Gharaibeh, m Matarneh, F. Al Quran, Novikov F. V. , Klenov, O. S, Andilahay A. A.
Keywords
Related Articles
- EP ID EP405987
- DOI 10.26480/jmerd.03.2018.74.81
- Views 68
- Downloads 0
ANALYSIS AND INNOVATION ON RDF DRYER MACHINE
The function of vibration is to smooth the flow of hot air into the Refuse Derived Fuel (RDF) which is put on the drying trays, so during drying process the door of drying chamber are not necessarily to be opened. The vi...
APPLICATION OF THE AUTOMATED SYSTEM-COGNITIVE ANALYSIS FOR SOLVING PROBLEMS OF GENETICS
This article describes an approach that provides the calculation of the amount of information in the genes about the characteristics or properties of different grape cultivars. A specific phenotypic property is considere...
INFLUENCE OF THE HUMAN-MACHINE SYSTEMS (HMS) OPERATION MODE ON THE INCREASE OF GRAIN-HARVESTING AGGREGATES PRODUCTIVITY
The article is devoted to the development of optimal operation modes of grain-harvesting aggregates, and the mechanizer is presented as an operator of the human-machine system (HMS). The block schematic diagram describes...
DRAG INVESTIGATION AROUND A CYLINDER AND SYMMETRIC AIRFOIL IN TANDEM WITH DIFFERENT GAPS AND ANGLES OF ATTACK
A Numerical simulation for the turbulent airflow around a symmetrical airfoil (NACA 0012) adjusted in tandem with circular cylinder, the airfoil were adjusted at variable angle of attack between (5-20°) with positive clo...
THE PROSPECTIVE PROCESSING LINE FOR THE PREPARATION OF COMPLETE FE ED FOR LONG-TERM STORAGE
An important condition for increasing the livestock production efficiency and production of livestock products and reducing their cost is full-value feeding, the provision to the farm animals complete multicomponent feed...