Theoretical research of some parameters of contact area of wheel cutting surface and workpiece at flat face grinding with preliminary inclination of spindle axis
Journal Title: Журнал інженерних наук - Year 2016, Vol 3, Issue 1
Abstract
Theoretical researches that have made it possible to obtain the analytical dependences connecting the parameters of contact area of wheel cutting surface such as length, width, arc length, form deviation of flat surface and workpiece under conditions of flat face grinding with preliminary inclination of spindle axis have been carried out. The paper shows the role of the angle of preliminary inclination of spindle axis, grinding depth and the wheel diameter in the grinding process. It allows correctly determining the value of the transverse feed (in multiple-pass processing) which, as it is known, should be conformed to the value of the contact width of the wheel cutting surface and workpiece. It guarantees that on the machined surface there will be no areas unaffected by the wheel. In case of through grinding the obtained theoretical dependences help to determine the processing conditions, taking into account the allowable values of form deviation of flat surface. All this makes it possible to improve the process of flat face grinding and thereby expand its technological capabilities.
Authors and Affiliations
I. Pyzhov, V. Klimenko
Keywords
Related Articles
- EP ID EP241681
- DOI -
- Views 49
- Downloads 0
Numerical Investigation of the Concave-Cut Baffles Effect in Shell-and-Tube Heat Exchanger
In this paper, the performance of shell-and-tube heat exchangers with single-segmental baffle and varying configurations of concave-cut baffles (10, 15 and 20 %) was investigated. The study was carried out for a heat exc...
Creating a simulation model of software testing using Simulink package
The determination of the solution model of software testing that allows prediction both the whole process and its specific stages is actual for IT-industry. The article focuses on solving this problem. The aim of the art...
Influence of the Wall Thickness Value on the Cross Wall Thickness Deviation of Tubes Rolled on the Tube Rolling Plant with the Continuous Mill
The high requirements as to accuracy of the wall thickness are due not only to necessity of assuring the reliability and serviceability of equipment, but also to the trend towards the continuous decrease of metal capacit...
Directions of the environmental protection processes optimization at heat power engineering enterprises
The article observes the impact factors of heat power engineering enterprises on the environment and ways of anthropogenic impact reduction during the application of ecological security control technological methods. The...
Polymeric compositional materials based on polycarbonate for units of devices for transform solar into thermal energy
Modern development of the industry is complicated without introduction of energy-saving technologies based on renewable natural energy sources. Solar and wind power plants, heat generators, solar collectors are wide spre...