Thermo-Mechanical Analysis of Sprayed Layers Using the Finite Element Method
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2016, Vol 39, Issue 1
Abstract
The present paper presents an analysis performed in order to determine the thermo-mechanical behavior at the layer-substrate interface in case of thermal spraying, by using the ANSYS R15.0 software. The analysis was made on high alloyed steel samples thermal sprayed on one side. For the 1st sample, the material used for the deposited layer was ZrO2 stabilized with Y2O3 (ZrO2+20% Y2O3) using the HVOF process. The 2nd sample was sprayed with stellite using the plasma spraying process. This analysis follows the idea of temperature distribution along with the other characteristics that define the thermal state in an object: the heat quantities released or absorbed, thermal gradient and thermal flow. In order to determine the causes of thermal expansions or contractions, the analysis is followed by a stress analysis. The obtained results show that the interface stresses are lower in the case of stellite coating, both steel and stellite having closer thermo-physical characteristics than steel and YSZ also including the intermediate layer.
Authors and Affiliations
Roxana-Alexandra GHEŢA, Bogdan DUMITRU, Gabriel Marius DUMITRU, Madalina Elena MILITARU
Keywords
Related Articles
- EP ID EP577292
- DOI -
- Views 107
- Downloads 0
The Dynamic Simulation for a Cold Rolling Mill Machine
For a cold rolling mill machine that represents a mechanical system, the dynamics problems may be solved by using the differential equations of their movement. We must consider all the connections and couplings for the m...
Cooling Rate Dependence of STructures Characteristics in Ce-Inoculated Low-S Grey Irons
The efficiency of Ce,Ca,Al-FeSi alloy was tested for lower addition rates (0.15-0.25wt.%), as, traditionally, high inoculant addition rates have been used in low sulphur grey cast irons, comparing to the base iron and co...
Improvement of Steel Sheet Corrosion Resistance by Thermic Coverage Method with ZincAluminium Alloys
The paper presents the main physico-chemical characteristics (viscosity and superficial tension of zinc-aluminium liquid alloy in view of carry out protected layers on steel sheet with very good properties by thermal met...
Growth Of ZnO 1-D Nanostructures By Chemical Bath Deposition Method Using Textured ZnO Seeds
A simple method has been developed to synthesize ZnO one-dimensional nanostructures on glass substrates from aqueous solution. The solution-based synthesis of oxide 1D nanostructures enables the fabrication of the next-g...
Austenitic Stainless Steels Corrosion Properties Modified by Silicon Alloying
In the present paper there are presented results concerning comparative corrosion resistance of some austenitic stainless steels, with or without silicon content. The silicon content is varying in the range of 1-5 %, in...