Thermomechanical Processing of Microalloyed Steels Used for Naval and Oil Industries
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2005, Vol 28, Issue 1
Abstract
This paperwork shows the laboratory experiments made on X60 and X65 steels with several intercritical thermomechanical treatment application. Two variants were used: “down-up” thermomechanical treatment with heating and rolling in the intercritical range and “up-down” thermomechanical treatment with preliminary complete austenitizing and rolling in the intercritic interval. High values of the strength characteristics and a good plasticity were gotten. A comparison was made with gotten results of the classical thermal treatment application (normalizing).
Authors and Affiliations
Ana DONIGA, Elisabeta VASILESCU, Sorin Miltiade ISTRATE, Silviu MĂCUŢĂ
Keywords
Related Articles
- EP ID EP664773
- DOI -
- Views 97
- Downloads 0
Electrical Properties of Ultra-Sonicated Epoxy Resin
As ultra-sonication is a mostly used method to disperse the particles into the polymer matrix, the aim of this study is to point out the effect of epoxy’s exposure to ultra-sounds over the electrical properties, especial...
Profilometric Analysis of Worn Surface of Bronze, Iron and Iron Composite Samples, by Pin-on-Disk Method
In this study are presented the results of profilometric analysis for the wear of bronze materials, cast iron and composite materials. These materials were tested under dry wear conditions, using "pin-on-disk" method on...
Increase the Steels Purity Cast in Vacuum
The need to develop products with special characteristics and high mechanical properties led to the introduction of plastic deformation of semifinished materials. Special purpose products are produced from slabs, blooms...
Structural Changes Associated with the Pseudoelastic Response of Fe-Based Shape Memory Alloys
The pseudoelastic responses of two types of iron base shape memory alloys (SMAs) were introduced and discussed. The former was based on Fe-Mn-Si system, obtained by classical (CM) and by powder metallurgy (PM) manufactur...
Contributions in the Domain of the Contact Stresses Between Cylinders of Cold Rolling
Elasto-plastic contact stresses between working cylinder and support cylinder of cold rolling using FEM are presented in this paper. Pressure and tractions resulted from the rolling process were obtained by using a calcu...