Triboinformatic Modeling of Wear in Total Knee Replacement Implants Using Machine Learning Algorithms
Journal Title: Journal of Materials and Engineering - Year 2023, Vol 1, Issue 3
Abstract
Pin-on-disk (PoD) tests, the most prevalent studies, are being carried out in order to evaluate tribological behaviour of different bearing materials. However, the comparison of results obtained from the PoD tests is very difficult. In this present study, several machine learning models were developed and trained and then these trained machine learning models were validated by quantifying forecasting error against the experimental data reported in literature. These machine learning based models can be utilized as alternative solution of PoD trials in order to minimize time consumption and experiment complexity.
Authors and Affiliations
Vipin Kumar, Ravi Prakash Tewari, Ramesh Pandey, Anubhav Rawat
Keywords
Related Articles
- EP ID EP727414
- DOI 10.61552/JME.2023.03.001
- Views 55
- Downloads 0
Effects of Applied Loads and Aluminium Nanoparticle Additions on Wear Resistance Properties of Particle Reinforced Epoxy Nanocomposites
The recent technology advancement has emerged aluminium nanoparticles for polymer reinforcements. Mechanical properties of epoxy containing aluminium nanoparticle was reported but its wear resistance is left unstudied. T...
QUALITY CONTROL IN THE MANUFACTURING INDUSTRY BASED ON THE APPLICATION OF COMPUTER VISION
Application of technologies based on information communication systems, internet networks, embedded systems, data storage in the cloud, computer vision, machine learning within manufacturing industry leads to a number of...
Effect of Cross-Sectional Profile of Circular Dimples on Hydrodynamic Lubrication Characteristics of Thrust Bearings
The effects of three types of dimples with different internal structures on the fluid lubrication characteristics of thrust bearings were investigated. The load-carrying capacity and the frictional torque were measured....
Simulation of Mechanical Processes at the Contact Region of a Dental Implant with Bone Tissues Under Shock Wave Treatment
Dental implants are becoming an increasingly important part of modern dental treatment. Developing an optimal implant surface design can improve osseointegration. Promising to increase the rate of osseointegration is the...
Increase of Wear and Heat Resistance of the AISI 304 Steel Surface Layer by Multi-Pass Nanostructuring Burnishing
The paper presents the results of experimental studies of the AISI 304 steel disc surface after finishing turning, electropolishing and nanostructuring burnishing after one and five passes of the tool with a natural diam...