Tribological Studies Regarding the Crude Rapeseed Oil Press
Journal Title: Analele Universitatii "Dunarea de Jos" din Galati. Fascicula IX, Metalurgie si Stiinta Materialelor - Year 2016, Vol 39, Issue 3
Abstract
The aim of this paper is to present a tribology test conducted on crude rapeseed oil press. The experiments were carried out with four-ball machine. The oil was tested at speed of 1000 rot/min and loads of 140 N and 200 N. Times of the test were 1200, 2400 and 3600 seconds. During the action of the 140 N load, the friction force has an almost linear increase, unlike the friction force recorded at the load of 200 N, when it was noticed a sharp increase in the range of 0 to 800 seconds, followed then by a stabilization of the friction force.
Authors and Affiliations
Liviu Cătălin ŞOLEA
Keywords
Related Articles
- EP ID EP577044
- DOI -
- Views 83
- Downloads 0
Electrochemical Corrosion Behavior of 7075 Aluminum Alloy after Ageing Treatment
The electrochemical corrosion behavior of 7075 aluminum alloy subjected to different artificial ageing treatments maintaining times was examined. This aluminum alloy is typically used in aerospace structural components s...
Influence of Cooling Oil on the Surface Quality of the Rolled Strip
The excess of emulsion used in the lamination process leads to the formation of drops which in the annealing process forms spots of burned emulsion. It was also shown to cause formation areas with high carbon concentrati...
Evaluation of the Occupational Risk Associated to Work Environment In Ferrous Metallurgy
Work environment present risk factors due to chemical pollution of ambient air with dust, smoke, fumes, vapors, mists and gases. Moreover physical risk factors (related to noise, lighting, temperature, vibration, humidit...
High-K Dielectric Inorganic-Organic Hybrid Thin Films for Field Effect Transistors (FETFT)
The paper discusses the challenges to develop thin films transistors for flexible transparent electronics, displays etc. The sol-gel preparation of hybrid thin films based on dielectric oxides nanoparticles (SiO2 NPs, Zr...
Siderurgy Slags Recovery in Building Industry
During the metallurgical processes of iron and steel elaboration, besides the basic products, it results a serious of secondary products (wastes) in high quantities but with a high recycle – recovery potential, and their...