TUNNEL EVALUATION IN CROCKER FORMATION BY GEOLOGICAL STRENGTH INDEX (GSI) SYSTEM: A CASE STUDY
Journal Title: Geological Behavior (GBR) - Year 2018, Vol 2, Issue 2
Abstract
This study was conducted to determine the value of Geological Strength Index (GSI), to predict rock mass properties, very unfavourable discontinuities combination and tunnel support pressure for rock bolts or shotcrete and to determine the suitability of GSI for a tunnel in Crocker Formation. Engineering geological mapping and discontinuity survey was done along the tunnel face as well as rock sampling. GSI values and the disturbance factor were obtained from field observation on the tunnel face. Point load and dry density test was conducted to determine the Uniaxial Compressive Strength (UCS) and unit weight, respectively. The rock mass properties, kinematic analysis and limit equilibrium analysis was used to determine the factor of safety (F.O.S) and pressure to stabilise the tunnel. The rock mass was characterised by 94.88 MPa UCS, 0.024 MN/m3 unit weight, widely space and high persistency. The GSI value is 50 with 0.8 disturbance factor. The cohesion, friction angle and tensile strength are 3.671 MPa, 25.20° and 0.056 MPa respectively. The friction angle was reduced by 5° due to lower shear strength of bedding plane. There are eight possibilities of discontinuities combinations on tunnel crown that have F.O.S lower than 2 and combination of joints 2, 4 and 6 has the maximum wedge volume of 28.37 m3. The maximum support pressure of rock bolts or shotcrete for F.O.S of 2 at the tunnel crown is 0.04 MN. The high F.O.S value may have been due to the overestimation of friction angle and cohesion of discontinuity plane. Then, this study shows that GSI system is unsuitable for the tunnel in study area which behave as anisotropic and structurally controls rock mass, but if needed, the values of rock mass properties, discontinuities combination and support pressure can be used for tunnel design.
Authors and Affiliations
Lee Kiun You,, Ismail Abd Rahim
Keywords
Related Articles
- EP ID EP402054
- DOI 10.26480/gbr.02.2018.21.24
- Views 54
- Downloads 0
URBANIZATION VS. ENVIRONMENTAL QUALITY: SOME OBSERVATION IN TELIPOK, SABAH, MALAYSIA
The study area is underlined by Crocker Formation of Eocene to late Early Miocene age and Quaternary deposit. Rapid urbanization activities have caused changes in land use. These activities accelerate higher rate of weat...
Comparison of Cohesion (c’), and Angle of Internal Friction (Ф’) Distribution in Highland Area of Kundasang by using Ordinary Kriging and Simple Kriging
The objective of the research is to determine the distribution of cohesion (c’), and angle of internal friction (Ф’) values for the highland area of Kundasang, Sabah by using kriging. A set of data from two adjacent site...
Smaller benthic foraminifera Analysis of Kudat Formation, Kudat, Sabah: Preliminary Interpretation
Small benthic foraminifera have been fully extracted from the mudstone of Kudat Formation, Kudat, Sabah. The Kudat Formation comprise thick-bedded, quartzose to feldspathic, locally calcareous sandstone, an overall abund...
Kampung Mesilou landslide: The controlling factors
This landslide study was conducted in Kampung Mesilou, Kundasang. Desk study, field study and data analysis used were based on recorded slides occurred in 2008, July 2013, November 2013 and June 2015. These episodic land...
SUITABILITY OF DBELA METHODS AS SEISMIC VULNERABILITY ASSESSMENT FOR BUILDINGS IN KOTA KINABALU, SABAH
Sabah experienced moderate seismicity in the active fault zones located in Kundasang, Ranau of 6.0 MW within minor damage recorded at Sabah recently. The damage following the earthquake and more than 100 aftershocks affe...