UHF PD Experiments on Real Power Transformer and its Frequency Characteristics Results
Journal Title: Engineering, Technology & Applied Science Research - Year 2016, Vol 6, Issue 1
Abstract
A number of methods have been used in partial discharge (PD) detection and recognition. Among these methods, ultra-high frequency (UHF) detection and recognition based on a single signal have attracted much attention. In this paper, a UHF PD detection system is built, and samples are acquired through experiments on a real power transformer. The received signal is decomposed into different frequency ranges through wavelet packet decomposition (WPD). In each frequency range, a pattern recognition neural network is built, and then the relationship between the information in that frequency range and PD type is described. By comparing the recognition accuracy of these networks, frequency range selection is optimized. In this specific case (the specific transformer, PD sources, and UHF sensors), results show that low frequency (156.25 MHz to 312.5 MHz) and high frequency ranges (1093.75 MHz to 1250 MHz) contain the most information for recognition. If a PD detection recognition system is to be designed, then the performance around these frequency ranges should be given attention.
Authors and Affiliations
H. Fan, J. Hu, H. Liu, Y. Yin, M. Danikas
Keywords
Related Articles
- EP ID EP109199
- DOI -
- Views 278
- Downloads 0
A Numerical Approach for the Determination of Mode I Stress Intensity Factors in PMMA Materials
An evaluation technique of the KI stress intensity factors (SIF) by a numerical investigation using line strain method is presented in this paper. The main purpose of this research is to re-analyze experimental results o...
Investigation of the Effect of Friction Stir Spot Welding of BH Galvanized Steel Plates on Process Parameters and Weld Mechanical Properties
This study evaluates the effect of Friction Stir Spot Welding (FSSW) pin shape on overlapping galvanized BH plates. FSSW is done at 4, 6 and 9 seconds dwell time at two rotational speeds (1500 and 1800 rpm) by tools with...
Experimental Evaluation of a Flat Plate Solar Collector Under Hail City Climate
Flat plate solar water heaters are widely used for water heating in low-temperature residential applications. In this paper the thermal performance of a solar flat plate water heater under Hail weather conditions (latitu...
Contributing Factors of Time Overrun in Public Sector Construction Projects
Time overrun is a major issue in construction projects. Its causes vary, depending upon the nature and size of the project. Developing countries are more susceptible to this problem due to limited resources and lack of m...
Effect of the Improved Pall Friction Damper on the Seismic Response of Steel Frames
Energy-absorbing dampers are used to reinforce structures which are vulnerable to earthquakes. This study evaluates the performance of Improved Pall Frictional Dampers (IPFD) which is a type of Pall Frictional Damper (PF...