Uji Kuat Tekan dan Daya Serap pada Batako dengan Menggunakan Metode Taguchi
Journal Title: Jurnal Sistem dan Manajemen Industri - Year 2018, Vol 2, Issue 2
Abstract
The brick making process has two very critical characteristics / Critical To Quality (CTQ) , namely compressive strength and water absorption. For the quality characteristics of the compressive strength the greater the value, the better (Higher The Better). As for the absorption of water the quality characteristics are getting smaller, the better (Smaller The Better). The quality of the brick used as building material must have good quality that can maintain the strength of existing buildings. The quality in question is the compressive strength and absorbency of water produced must be in accordance with the requirements of SNI (Indonesian National Standard). The WS companies produce concrete blocks which have not good quality. The bricks are brittle. The method used in this study is the Taguchi method. Optimal Level Factor setting is Factor A (duration of stirring), Factor B (Pressure), Factor C (Water), Factor D (Drying) and Factor E (Composition of Sand and Lime). Where the optimal factor setting level factor that is most influential and dominant in compressive strength and water absorption is factor E (composition of sand and lime). For compressive strength factor E (sand and lime composition) level 2, 1: 0.25 and for absorption factor E (composition of sand and lime) level 1, 1: 0.5. and to confirm the results of this experimental design study, a percentage of Quality Loss Function of compressive strength and water absorption was obtained after the optimal level setting had a quality increase of 51.91% and a decrease in the Loss function of 78.5%.
Authors and Affiliations
Akhmad Sutoni
Keywords
Related Articles
- EP ID EP428885
- DOI 10.30656/jsmi.v2i2.711
- Views 106
- Downloads 0
Perancangan dan Pengembangan Bed Shower Menggunakan Metode Quality Function Deployment (QFD) Berdasarkan Prinsip Ergonomi
This research was conducted to design a bed shower and study the design and development of a bed shower for patient needs. The purpose of creating a bed shower is because of the lack for these tools to make it easier for...
PENGUATAN KAPASITASMASYARAKAT MELALUI INOVASI FORMULASI KEBIJAKAN PERENCANAAN PEMBANGUNAN PARTISIPATIF DI KECAMATAN WANASALAM KABUPATEN LEBAK
The purpose of this community service activity is to co-ordinate with the community in developing innovative and participatory development planning policy formulation in a sustainable manner to produce the document as re...
Aplikasi Seven Tools untuk Mengurangi Cacat Produk White Body pada Mesin Roller
This study aims to demonstrate effectively application of the seven tools as one of the quality management tools to reduce product defects. A case study has been conducted in the production of white body at PT. XYZ, whic...
Usulan Penerapan Total Productive Maintenance pada Transfer Conveyor 17A
The quantity and quality of coal affects the efficiency of the generating unit, therefore the utilization of Transfer Conveyor 17A is very necessary to fulfill the fuel requirement (coal) of PT Indonesia Power Unit Gener...
Analisis Sistem Antrian Pelayanan Registrasi Mahasiswa di BAAK Universitas Tridinanti Palembang
Administrative Bureau of Academic and Student Affairs (BAAK) Tridinanti University of Palembang (UTP) is an institution that serves the academic administration and UTP student affairs. The approval of the KRS (Card Study...