Use of the JM- SPC software to statistical control of high pressure die casting production-variable valued data type
Journal Title: Archiwum Odlewnictwa - Year 2009, Vol 9, Issue 3
Abstract
Usefulness of the JM-SPC computer program for a statistical analysis of variable valued data proceeded from an Al-Si high-pressure die casting production processes was examined. An analysis subject were results of dimensional measurement of 16 casting dimensions systematically controlled on coordinate-measuring machine. For analysis two criterion have been used: 1) X-s control chart and the performance indicator of processes by using of two commonly used indices: potential process capability index (Cp) and process capability index (Cpk).
Authors and Affiliations
J. Mutwil, A. Lehmann, Ł. Kremens, P. Gruszczyński
Keywords
Related Articles
- EP ID EP72014
- DOI -
- Views 70
- Downloads 0
Crystallisation and microstructure of low-silicon silumins with alloy additions
The paper presents the results of the analysis of crystallisation and microstructure of non-alloy silumins that contain: 2,0÷6,0% of Si and alloy additions, approximately: 4,0% Ni, 4,0% of Cu and 0,5% of Mg, the knowledg...
Influence of technological factors on eutectic silicon morphology in Al-Si alloys
From the background about Al-Si alloys modifying from eutectic silicon morphology and mechanical properties relation point of view is at solving of chosen technological problems used structural analysis and Si morphology...
Three-dimensional numerical model of solidification with motion of the liquid phase
The paper presents numerical modeling of solidification process with convective motion of the liquid phase, generated both in the liquid and mushy zones. The transition region between the areas filled with liquid and sol...
Effect of applied pressure on the quality of squeeze cast parts made from AlSi9Mg alloy
The results of the study of an influence of pressure in the direct squeeze casting process on the physical and mechanical properties of an AlSi9Mg alloy are presented. The specimens were made by casting the tested AlSi9M...
Plastic properties of cold-deformed ironbased sintered materials
Cold plastic forming of sintered metal powders has limited practical application because of, among others, the deformation degree and initial porosity of preforms. Cold forming is combined with a very drastic drop of pla...