VIBRATION ANALYSIS AND REPAIR PROCESS FOR THE VENTILATION SYSTEM FOR SMOKE DRAIN IN THE THERMAL POWER PLANT
Journal Title: Applied Engineering Letters - Year 2018, Vol 3, Issue 1
Abstract
Vibrations are common phenomenon in the rotating machinery, which could carry important information about condition of the rotating machinery. All specific failures in rotating machinery have their own characteristics of the vibrations. By measuring and analysis of vibrations cause of increased vibrations could be determined. Since misalignment and rotating looseness have similar frequency spectrum characteristics, it is difficult to determine which one of the failures is present. When cause of increased vibrations is determined, it is possible to plan the future steps for the repairing and neutralising present cause of the possible failure. Process of vibration analysis followed by present cause of increased vibration in rotating machinery repairing is presented in this paper through example on the ventilation system for smoke drain in the thermal power plant.
Authors and Affiliations
Emir Nezirić, Safet Isić, Edin Džiho
Keywords
Related Articles
- EP ID EP283262
- DOI 10.18485/aeletters.2018.3.1.7
- Views 87
- Downloads 0
HIGH AND ULTRA – HIGH CYCLE FATIGUE OF C55 HIGH GRADE CARBON STEEL
Article provides experimental results in the field of ultra-high cycle fatigue behaviour of C55 high grade carbon steel obtained at highfrequency loading (f ≈ 20 kHz, T = 20 ± 10 °C, R = -1). The results confirm a contin...
OPTIMIZATION OF EFFICIENCY OF WORM GEAR REDUCER BY USING TAGUCHI-GREY METHOD
In this paper the efficiency and output power are considered, as the most important characteristics of the worm gear reducer, and their optimization was performed. As the influencing factors, the viscosity of the lubrica...
INDUCING THE BIODEGRADABILITY OF POLYMERIC COMPOSITE MATERIALS USING BIORANFORTS
The purpose of the research is to obtain composite materials with high structural, thermo-mechanical and / or tribological performances, according to ecological norms and international requirements in order to replace th...
AN INTEGRATED APPROACH FOR DESIGN AND MANUFACTURE OF PLASTIC PRODUCTS
The aim of this paper is to present an integrated design procedure for plastic part development and manufacture. Reverse engineering (RE), re-engineering (ReE) and mold design have been incorporated to infuse agile chara...
THE IMPACT OF VOLUME FRACTION METAL/CERAMIC CONSTITUENTS ON CRITICAL BUCKLING TEMPERATURE OF FUNCTIONALLY GRADED PLATE
A thermal buckling analysis of functionally graded rectangular plates is presented. Mechanical and thermal properties of the functionally graded material, except Poisson’s ratio, are assumed to vary continuously through...