WEAR-RESISTANT AND CORROSION-RESISTANT LAYERS OF NEW GENERATION PRODUCED IN THE VACUUM TITANIZING PROCESS ON TOOL STEEL
Journal Title: Tribologia - Year 2015, Vol 262, Issue 4
Abstract
The paper presents the results of examinations of the structure and properties of duplex layers of the TiC+(Ni-W) type, produced in the vacuum titanizing process on a tool steel surface covered with Ni-W electrolytic alloy. A comparison of the TiC+(Ni-W) type duplex layers with the TiC type single carbide layers produced on steel surface in the vacuum titanizing process was performed. Investigations of layers morphology, their phase composition, depth profiles, and hardness were conducted. Tribological properties (linear wear) of the layers were determined by means of taper-three rolls test. The results prove that the wear resistance to friction of the TiC+(Ni-W) type duplex layers produced by means vacuum titanizing of tool steel covered with Ni-W alloy electrolytic coating are as good as single carbide layers of the TiC type, whereas tribological properties of the hardened steel samples without any layers were not good.
Authors and Affiliations
Ewa KASPRZYCKA, Bogdan BOGDAŃSKI
Keywords
Related Articles
- EP ID EP257258
- DOI -
- Views 48
- Downloads 0
KINDS LASER TEXTURING IN TRIBOLOGY
The idea laser texturing was introduced in the article, his the author's mislaid in the aerology and the ideological patern of various textures. Chosen examples were introduced technological uses laser texturing in the e...
THE EFFECT OF ABRASIVE SOIL MASS DENSITY ON THE TRIBOLOGICAL PROPERTIES OF STEEL
Even though soil mass density is among the basic characteristics of a soil mass, it has not been analysed in terms of wear impact on steel. This paper presents the results of testing for the wear of abrasion-resistant st...
THE ANALYSIS OF MEASUREMENT DATA COLLECTION SYSTEMS FROM THE TRIBOTESTERS
When conducting tribological model studies with the aim of achieving a high repeatability and reproducibility of results, much attention is paid to the precise setting of test parameters. Most of all, setting the sliding...
COMPARATIVE ANALYSIS OF ABRASIVE WEAR-RESISTANCE OF BRINAR AND HARDOX STEELS
One of the most important problems encountered during operation of machine parts exposed to abrasive action is their wear. In addition, these parts often work under dynamic loads, so their satisfactory ductility is also...
MICROSTRUCTURE AND CHEMICAL COMPOSITION OF BOUNDARY LAYERS FORMED WITH BIOCOMPONENTS OBTAINED FROM REFINING RAPESEED OIL
This article presents the results of the investigation of structure and chemical composition of wear scar surfaces that influence antiwear characteristics of bioadditives received from waste materials from refining of ra...