A GENERALIZED METHOD FOR PREDICTING CONTACT STRENGTH, WEAR, AND THE LIFE OF INVOLUTE CONICAL SPUR AND HELICAL GEARS: PART 2. HELICAL GEARS
Journal Title: Tribologia - Year 2018, Vol 277, Issue 1
Abstract
The paper presents the results of research undertaken to determine maximum contact pressures, wear, and the life of involute conical helical gear, taking account of gear height correction, tooth engagement, and weargenerated changes in the curvature of their involute profile. We have established the following: (a) initial maximal contact pressures will be almost the same at the engagement in external and internal segments; (b) their highest meanings occur in different points of engagement depending on the coefficients of displacement; (c) the maximal tooth wear of the rings in the internal section will be a little bit lower than in the external; (d) the coefficients of displacement have an optimum at which the highest gear life is possible; and, (e) the gear life in the frontal section will be 1.25 lower than in the internal section. The calculations were made for a reduced cylindrical gear using a method developed by the authors. The effect of applied conditions of tooth engagement in the frontal and internal sections of a cylindrical gear ring is shown graphically. In addition, optimal correction coefficients ensuring the longest possible gear life are determined.<br/><br/>
Authors and Affiliations
Myron CHERNETS
Keywords
Related Articles
- EP ID EP346095
- DOI 10.5604/01.3001.0011.8278
- Views 56
- Downloads 0
THE STRUCTURE AND COEFFICIENT OF FRICTION OF WELDED NICKEL ALLOYS INCONEL 625 AND INCONEL 718
In this study, the coefficients of friction for three series of welded nickel alloy joints, subjected to different heat treatments (lack of heat treatment, solution heat treatment, precipitation hardening), were determin...
Mechanizm konstytuowania warstwy granicznej z uwzględnieniem zjawisk triboelektrycznych
W strefie tarcia, gdy środek smarowy rozdziela dwie powierzchnie, w odpowiednich warunkach zaczynają występować cząsteczki nieobojętne elektrycznie (polarne, naelektryzowane i zjonizowane) w znacznych stężeniach. Cząste...
THE USE OF PLATE SPRINGS FOR PRELOADING OF A SYSTEM OF TAPERED ROLLER BEARINGS OF A WIND TURBINE GEARBOX
The use of preloaded tapered roller bearings in wind turbine drive systems allows a transfer of load in the case of high variations of axial forces. The examined bearing system, a modification of a current design, consis...
THE TRIBOLOGICAL PROPERTIES OF COATINGS LUBRICATED WITH A BIODEGRADABLE CUTTING FLUID
This paper presents the tribological results of on investigations of TiAlN coatings that were deposited on HS6-5-2C steel using the physical vapour deposition PVD technique. An observation of the coating structure was ca...
ANALIZA WŁAŚCIWOŚCI TRIBOLOGICZNYCH WYBRANYCH KOMPOZYTÓW POLIMEROWYCH NA BAZIE PTFE WSPÓŁPRACUJĄCYCH ŚLIZGOWO Z TLENKIEM GLINU (Al2O3)
W artykule przedstawiono mikrostrukturę, właściwości mechaniczne i tribologiczne kompozytów polimerowych na osnowie politetrafluoroetylenu z myślą o zastosowaniu w węzłach tarcia urządzeń realizujących ruch posuwisto-zwr...