THE STRUCTURE AND COEFFICIENT OF FRICTION OF WELDED NICKEL ALLOYS INCONEL 625 AND INCONEL 718
Journal Title: Tribologia - Year 2018, Vol 281, Issue 5
Abstract
In this study, the coefficients of friction for three series of welded nickel alloy joints, subjected to different heat treatments (lack of heat treatment, solution heat treatment, precipitation hardening), were determined. Heat treatment of the prepared samples was aimed at eliminating the structural and stress gradient, because the electron beam welding technique is dedicated for constructions with very high quality and strength requirements. Given the nature of the electron beam process, the authors are aware that the obtained weld’s structures are characterized by different properties from parent materials, and also from structures melted under equilibrium conditions. The scientific aim of the presented work is to determine the influence of heat treatment on the microstructure, mechanical properties, and performance of dissimilar joints of nickel alloys Inconel 625 and Inconel 718. In order to determine the coefficient of friction for samples, the scratch test method was used. As a result of the research, it was proved that subjecting the welds to the precipitation hardening has a significant effect on abrasion resistance.<br/><br/>
Authors and Affiliations
Katarzyna STRZELCZAK, Agata DUDEK
Keywords
Related Articles
- EP ID EP417487
- DOI 10.5604/01.3001.0012.7660
- Views 45
- Downloads 0
ANALYSIS OF THE ASSESSMENT OF THE CONSUMPTION STATE OF CONCRETE ABRASIVE SURFACES USING SPATIAL SCANNING
The article presents the results of the analysis of surface damage of abraded underwater concretes with the use of spatial scanning. The concrete abrasion test was carried out using the ASTM C1138 underwater method. Spat...
SHAPES OF NANO-GROOVES AND RIDGE SHAPES ON MICRO-BEARING SURFACES
In micro-bearings, where journal diameter has values up to 1 millimetre and the height of the micro-bearing gap has the largest value 1 micrometer, the intelligent features are attained by the groove and ridges on the sl...
INFLUENCE OF EROSIVE PARTICLES IMPACT ANGLE ON EROSIVE WEAR INTENSITY OF POLYURETHANE COATINGS
The article presents examination results of the influence of alundum particle impact angle on the kinetics of the erosive wear of polyurethane coatings. Examined three-layer polyurethane coatings of an average thickness...
ALGORYTHM FOR VARIABLE PSEUDOVISCOSITY COEFFICIENTS UNDER AN EXPERIMENTAL BASIS
Constitutive equations between stresses and deformations for oils with pseudo-viscosity properties are usually described by the Rivlin-Ericksen relations. In these relations two pseudo-viscosity coefficients occur. Up to...
Właściwości reologiczne biododatków pochodzenia roślinnego o działaniu przeciwzużyciowym
Przedstawiono wyniki badań tribologicznych i reologicznych modelowych kompozycji smarowych zawierających biododatki otrzymane z surowców odnawialnych (olejów roślinnych). Stwierdzono, że działanie biododatków uzależnione...