About the operation efficiency increase of high-power shunt reactors
Journal Title: Вісник Національного технічного університету "ХПІ". Серія: Проблеми удосконалювання електричних машин і апаратів. Теорія і практика - Year 2014, Vol 41, Issue 1084
Abstract
Ways to increase the voltage quality in energy-intensive customers’ networks are investigated. Presence of the reactive power in transmission networks decreases essentially quality of electric energy input that results in power losses, voltage subsidences and drops in power transmission lines, enforced increase of power transformers’ power and cable sections in such networks. An engineering solution to decrease additional losses of a shunt reactor is proposed, analysis of different types of winding wire influence on this losses is carried out.
Authors and Affiliations
L. B. Zhorniak, V. I. Osinskaia, A. S. Paltsun
Keywords
Related Articles
- EP ID EP408979
- DOI -
- Views 116
- Downloads 0
The main relationships for calculations in two-circuits resonant amplifier of the electric power
Based on a Tesla transformer and an idealized circuit of two consecutive reactive active inductively coupled circuits with zero active resistance of the secondary circuit, a scheme of a resonant electric power amplifier...
Automation of control by feed-pumps of a 200 MW power unit
A review and analysis of control systems and relay protection of feed-pumps and technical requirements of them are carried out. Possibility of replacement of the relay control system is reasonable to the automatic system...
The system of optimal control of the motion of a traction unit with synchronous motors on permanent magnets
An approach is proposed to automatic control of the speed of traction unit with synchronous motors on permanent magnets containing starter windings, which is based on the use of reduced–order observers. An equation of Lu...
Development and research of system of automatic control of electric traction
Were developed by structural schemes of automatic control system of traction electric drive based on a synchronous motor with permanent magnets, the use of which allows you to control the motion of electric contact locom...
Use of diagnostic data of the main drives of the rolling mills in automatic measurement systems of products length measurement
The study of measuring system was carried out in rolling shop. The complex was proposed based on a mathematical model of the rolling process and 650 mill diagnostic data. The paper describes mathematical modeling of a co...