Adaptive Pi Control of Statcom for Voltage Regulation

Abstract

Static compensator (STATCOM) can provide fast and efficient reactive power support to maintain power system voltage stability. In the literature, various STATCOM control methods have been discussed including many applications of proportional-integral (PI) controllers. However, these previous works obtained the PI gains via a trial-and-error approach or extensive studies with a tradeoff of performance and applicability. Hence, control parameters for optimal performance at a given operating point may not be as effective at a different operating point. This paper proposes a new control model based on adaptive PI control, which can self-adjust the control gains during a disturbance such that the performance always matches a desired response, regardless of the change of operating condition. Since the adjustment is autonomous, this provides the plug-and-play capability for STATCOM operation. In the simulation test, the adaptive PI control shows consistent excellence under various operating conditions, such as different initial control gains, different load levels, change of transmission network, consecutive disturbances, and a severe disturbance. In contrast, the conventional STATCOM control with tuned, fixed PI gains usually performs fine in the original system with a fuzzy logic controller, but may not perform as efficiently as the proposed control method when there is a change in system conditions.

Authors and Affiliations

Mr. G. Varaprasad, Dr. D. Obulesu

Keywords

Related Articles

Design and Development of a Warning System for Early Season Control of Powdery Mildew Affecting Agricultural Crops.

The crop management system using Wireless Sensor Network (WSN) is a kind of an autonomous solution to plant disease detection, an essential and critical operation which affects yield, cost and environmental protection ag...

A Solar-Photovoltaic Grid Interface Systemusing Smc Based On Lyapunov Function

A sliding mode control technique (SMC) is used for achieving maximum power point tracking (MPPT) control of solar-PV array. The Lyapunov function-based control technique is designed and developed for the DC-AC inverter t...

Substation Earthing Design

Successful operation of entire power system depends to a considerable extent on efficient and satisfactory performance of substations. Hence substations in general can be considered as heart of overall power system. In a...

Optimization of Cutoff Frequency Limits of Microstrip Circular Patch Antenna Printed on Ferrite Substrate by Artificial Neural Network Analysis

General artificial neural network (ANN) analysis has been applied to optimize the lower and upper frequency limits of cutoff region of switchable microstrip circular patch antenna printed on ferrite (LiTiZn) substrate in...

Cost Comparison in LED Lighting and Selection Criteria in LEDs

In this study, LED selection criteria, comparative technical data of LEDs and other lamps and price analyzes are evaluated. In addition, today’s development of LED technology is examined and the reasons for using LED lam...

Download PDF file
  • EP ID EP388245
  • DOI 10.9790/1676-1204040110.
  • Views 166
  • Downloads 0

How To Cite

Mr. G. Varaprasad, Dr. D. Obulesu (2017). Adaptive Pi Control of Statcom for Voltage Regulation. IOSR Journals (IOSR Journal of Electrical and Electronics Engineering), 12(4), 1-10. https://europub.co.uk/articles/-A-388245