Sepic Topology Based High Step-Up Step down Soft Switching Bidirectional DC-DC Converter for Energy Storage Applications
Journal Title: IOSR Journals (IOSR Journal of Electrical and Electronics Engineering) - Year 2017, Vol 12, Issue 3
Abstract
SEPIC topology based bidirectional DC-DC Converter is proposed for interfacing energy storage elements such as batteries & super capacitors with various power systems. This proposed bidirectional DC-DC converter acts as a buck boost where it changes its output voltage according to its duty cycle. An important factor is used to increase the voltage conversion ratio as well as it achieves high efficiency. In the proposed SEPIC based BDC converter is used to increase the voltage proposal of this is low voltage at the input side is converted into a very high level at the output side to drive the HVDC smart grid. In this project PIC microcontro9 ller is used to give faster response than the existing system. The proposed scheme ensures that the voltage on the both sides of the converter is always matched thereby the conduction losses can be reduced to improve efficiency. MATLAB/Simulink software is utilized for simulation. The obtained experimental results show the functionality and feasibility of the proposed converter.
Authors and Affiliations
Deepa devi, Bijo Merlin, M, Arunsankar . G
Keywords
Related Articles
- EP ID EP387303
- DOI 10.9790/1676-1203046876.
- Views 151
- Downloads 0
A Comparative study on Different ANN Techniques in Wind Speed Forecasting for Generation of Electricity
There are several available renewable sources of energy, among which Wind Power is the one which is most uncertain in nature. This is because wind speed changes continuously with time leading to uncertainty in availabili...
Analysis and Development of a Reliability Forecasting Model for Injection Substation
This paper is aimed at analyzing and developing a reliability forecasting model for an Injection Substation; a case study of Ugbowo 33/11kV Injection Substation. This project seeks to determine the current reliability st...
Enhancing the Performance of P3HT/Cdse Solar Cells by Optimal Designing of Active Layer
The present study examined the influence of different condition like as doping , in active layer, on the performance of P3HT/CdSe Solar cells .In this work, we analyzed the best doping for the configuration of P3HT/ CdSe...
Use of polymers at electroinsulating parts production
Main objective of work is generalization of researches results in a polymers scope as electroinsulating material. Key parameters of electroinsulating parts are considered. Characteristics and recommendations about use of...
Hybrid Renewable Energy System for Agriculture Irrigation
Hybrid (Solar & Wind) renewable power system can be used to preserve the non-renewable fossil fuels. The Photovoltaic-wind hybrid system profits the lowest unit cost values to sustain the same level of Deficiency of Powe...