AERODYNAMIC AND THERMAL DESIGN OF CENTRIFUGAL COMPRESSOR FOR SMALL SCALE IN NON-DIMEMSIONAL FORM

Abstract

In the present study, a 3D numerical simulation of a non-dimensional design of impeller, diffuser and volute design of centrifugal compressor in dimensional form is carried out by using the commercial code of ANSYS R15.0. The fully 3D, Compressible and Steady flow analysis of the fluid (air) flow were solved in CFX solver. A SST k-v turbulent model was used for a simulation of the on-design performance of the single speed centrifugal compressor. By using this specific design results show that De-Haller number, non-dimensional mass flow rate, non-dimensional ratio of axial length to exit diameter, divergence angle of Diffuser, area ratio from diffuser outlet to volute outlet obtained in order to 0.7, 0.092, 0.33, 7.29 and 0.65 respectively. Also, found that All Mach number are below 1 so there are no shock formations. The mass flow rate is less than chocking mass flow rate at the throat of impeller and diffuser so there is no choking of flow In order to verify the present numerical simulations, the model results were validated with the analytical method gives the good agreement but not exactly due to design losses were neglected.

Authors and Affiliations

SAMKIT V. SHAH, BIPIN G. VYAS, ARUN BOLLAVARAPU, SHIRISH PATEL

Keywords

Related Articles

Experimental Investigation on Corrosion Behaviour of Hot Upset P/M Plain Carbon Steel

The experimental work endeavors to examine the mechanism behind the corrosion phenomenon of sintered-hot upset plain carbon steel under induced corrosion acid pickling condition. The alloy powder mix of Fe-0.5%C was comp...

Effect of Screen Mesh Wick and Al2o3 Nanofluid Concentration on Circular Heat Pipe Performance

It is a passive heat transfer device that is used to remove the amount of heat from the heat source. The behavior of screen wick and nanofluid to improve the performance of a heat pipe.Al2O3 /DI-water based nanofluid is...

Investigation of Production Output for Improvement

Experimental determination and evaluation of ten (10) different production lines producing different brands and sizes of alcohol beverages was carried out on each of the lines according to the standard operating procedur...

Fabrication of Aluminium 6061- SiC-Al2O3 MMC and HMMC by Strir Casting Technique and Comparing the Mechanical Properties

Aluminum alloys are extensively used in aerospace and automobile industries owing to their low density and good mechanical properties, superior corrosion resistance and wear, low thermal coefficient of expansion as compa...

Model and Analysis of Desktop Wind Tunnel

This paper is on model and analysis of desktop wind burrow. Wind Tunnel (WT) is equipment used to research a communication between rigid body flows in WT that can be performed in term of observing physical stream phenome...

Download PDF file
  • EP ID EP222581
  • DOI -
  • Views 166
  • Downloads 0

How To Cite

SAMKIT V. SHAH, BIPIN G. VYAS, ARUN BOLLAVARAPU, SHIRISH PATEL (2017). AERODYNAMIC AND THERMAL DESIGN OF CENTRIFUGAL COMPRESSOR FOR SMALL SCALE IN NON-DIMEMSIONAL FORM. International Journal of Mechanical and Production Engineering Research and Development (IJMPERD ), 7(2), 81-92. https://europub.co.uk/articles/-A-222581