Aluminium Cutting Specific Issues
Journal Title: RECENT - Year 2011, Vol 12, Issue 33
Abstract
In this paper the difficulties of cutting pure aluminium, used mainly in large electrical contacts of high voltage equipment are presented. It can be noted that during the cutting without cutting liquid, at certain regimes, the chips are glued on the channel of the front face, remaining there and blocking the channel and cutting edge, so that accidents occur. Also, different forms of chips resulted after cutting with different regimes, indicating in each set of chips used in the cutting regime are studied. The microscopic images of chips, as seen from the outside and from the area that came into contact with cutting edge of bit are shown. The deposition under the cutting edge of bit after cutting at different cutting regimes and different geometrical parameters of used drawknife are presented. Images of cutting edges are given with elements of chips on them and microscopic images where the variation of deposit thickness and edge clearance are shown.
Authors and Affiliations
Iulian POPESCU, Cristina PASCU
Torque Ripple Reduction in Direct Torque Control Induction Motor Drive Using SVM and FLDRC
Direct Torque Control (DTC) is a control technique used in AC drive systems to obtain high performance torque control. The conventional DTC drive contains a pair of hysteresis comparators, a flux and torque estimator and...
The Macroscopic Analysis of Samples Cut With a CO2 Laser Type TC L4003
In industrial practice, metal materials such as steel, tool steel, stainless steel, aluminium and aluminium alloys are cut using laser (considered an allied welding process). But laser can also cut materials such as tita...
Aspects Regarding Mechanized Thermal Plasma Cutting of Metallic Materials - Carbon Steel
The purpose of this paper is to present an up to date analysis concerning the status of mechanized thermal cutting procedures, which have to be taken into account when settling the manufacturing technology in industrial...
Research on the Efficiency of Thermally Insulated Feeders
The paper discusses the influence of thermal insulation of feeders on the solidification of cast parts. The employed method was computer simulation of alloy solidification. Several casting variants were analyzed involvin...
Quaternion Accuracy Model of Industrial Robots
The article describes existing methods and approaches to industrial robots accuracy simulation based on the matrix methods at multiply industrial robots’ motions. The main problems and disadvantages of using these existi...