Analysis and Optimization of Turned Surfaces of AISI 1060 using ANOVA and Regression
Journal Title: Tribology in Industry - Year 2019, Vol 41, Issue 1
Abstract
AISI 1060 carbon steel for turning process is used to find out best cutting parameters using Analysis of Variance (ANOVA) and Regression Concept. Optimization of cutting parameters in turning operation is analyzed in this study. Cutting speed and force affects remarkably on the roughness on the surfaces of the test sample at all cutting operations. The reasonable surface roughness was obtained at a low feed rate in the combination of high cutting speed. Tool vibration was increased with the depth of cut and feed rate. In this study surface roughness was obtained which mostly dependent on the cutting speed, that contribution was 59.74 % and feed rate contribution was found as 13.75 %. The A multilinear regression model was developed to correlate the different cutting parameters.
Authors and Affiliations
M. A. Chowdhury, U. K. Debnath, Md. Kamruzzaman, D. M. Nuruzzaman
Keywords
Related Articles
- EP ID EP573742
- DOI 10.24874/ti.2019.41.01.03
- Views 93
- Downloads 0
Research Regarding Drilling Masts Reliability under the Combined Action of the Wind and the Hook Load
Portable masts are parts of mobile servicing rigs designed to work at drilling or extraction wells and are made of three sections: fixed section, lower section and upper section. During transportation, the mast is placed...
Friction and Adhesion in Porous Biomaterial Structure
The paper presents short review of different aspects of the introduction of porosity into the bulk biomaterial and effects on different material characteristics, especially related to friction and adhesion. Nowadays, the...
Wear Properties of A356/10SiC/1Gr Hybrid Composites in Lubricated Sliding Conditions
This paper presents basic tribological properties of A356/10SiC/1Gr hybrid composites in conditions with lubrication. Hybrid composite specimen is obtained by compocasting procedure. A356 aluminium alloy is used as a bas...
Comparative of the Tribological Performance of Hydraulic Cylinders Coated by the Process of Thermal Spray HVOF and Hard Chrome Plating
Due to the necessity of obtaining a surface that is resistant to wear and oxidation, hydraulic cylinders are typically coated with hard chrome through the process of electroplating process. However, this type of coating...
Tribological and Thermal Investigation of Modified Hot Stamping Tools
Direct hot stamping is an established manufacturing process to produce safety-relevant car body components, while t-he hot blank is formed and quenched simultaneously in a water cooled press. In order to protect the semi...