ANALYSIS OF CONTACT AND BENDING STRESSES IN GEARBOX SWITCHING UNDER LOAD
Journal Title: Tribologia - Year 2017, Vol 274, Issue 4
Abstract
The work analyses contact stresses that occur within the active surface of toothed gears as well as bending stresses that take place at the tooth root. Contact stresses have been designated at the beginning of the singletooth engagement area within the pitch point and in the end of single-tooth engagement area. Designation of bending stresses at the tooth root has been made by applying the interteeth force to the external point of single-tooth engagement. The calculated numerical values of contact and bending stresses were compared to fatigue contact durability σH lim and fatigue bending strength σF lim that were obtained experimentally. Calculations of contact stresses and bending stresses were done with multi-criterion optimisation, which makes it possible to select such geometrical parameters of toothed gears that allow utilizing fatigue durability σH lim and σF lim in reference to a given material and technology of manufacturing toothed gears.
Authors and Affiliations
Jan ZWOLAK, Marek MARTYNA
Keywords
Related Articles
- EP ID EP238747
- DOI 10.5604/01.3001.0010.6050
- Views 111
- Downloads 0
ESTIMATION OF THE WEAR MECHANISM IN SLIDING CONTACT OF SATELITE GEARS OF A HYDRAULIC MOTOR
The paper presents tests of the wear of selected elements of a hydraulic satellite engine in sliding contact. The tests were carried out on the tribotester T-05 in a roll-block system, taking into account the influence o...
Badanie skuteczności cieczy antyscuffingowych stosowanych podczas transportu butelek na przenośnikach
Podczas transportu butelek szklanych na przenośnikach powierzchnie ich ulegają uszkodzeniu w miejscach styku. Powstają ślady zużycia w postaci pierścieni na obwodzie. Przeciwdziałanie temu procesowi polega między innymi...
THE EFFECT OF THE KIND AND CONCENTRATION OF POLYVINYLPYRROLIDONE ON SELECTED TRIBOLOGICAL CHARACTERISTICS IN AQUEOUS SOLUTIONS
The subject of the physicochemical and tribological studies were two kinds of polyvinylpyrrolidones with the degrees of polymerization of 450 (PVP 450) and 14,400 (PVP 14,400). A significant effect of the degree of polym...
WŁAŚCIWOŚCI TRIBOLOGICZNE KOMPOZYTÓW TLENEK GRAFENU-METAL
Kompozyty Cu-C są materiałami używanymi do produkcji szczotek, styków i ślizgów do maszyn elektrycznych ze względu na ich dobre właściwości mechaniczne i odporność na zużycie. Cechy te obejmują dobre przewodnictwo ciepln...
PROBLEMS OF THE SURFACE LAYER TECHNOLOGICAL FORMING IN THE ASPECT OF THE SCUFFING PERFORMANCE. PART II: THE TOPOLOGICAL APPROACH
The proposition of the topological approach to the technological creation of the surface layer’s scuffing performance is presented in this article. It was recognized, based on the cycle of experiments, that the scuffing...