ANALYSIS OF ELECTROMAGNETIC PROCESSES IN THE SYSTEM «CYLINDRICAL SOLENOID – MASSIVE CONDUCTOR»
Journal Title: Електротехніка і Електромеханіка - Year 2018, Vol 0, Issue 1
Abstract
Purpose. Defining the key parameters of the inductor geometry, as a long multi-turn solenoid, that influence on the current amplitude induced excited in a massive conductor with a flat boundary surface. Methodology. Performing a mathematical analysis of the electrodynamic problem solution for an area with variable structure by integrating Maxwell's equation within the given boundary and initial conditions and also physical assumptions simplifying the process of solving but not distorting the result and carrying out an experiment that confirms not only the correctly construction considered but also the acceptability of the chosen assumption the opacity applying of the metal blank for these operating fields frequencies. Results. Functional dependencies of the current induced parameters on the metal surface of the heating object have been obtained, along which numerical estimates of the electrodynamic process have been performed, and key parameters influencing the heating efficiency have been determined. The correctness of the solutions obtained was confirmed experimentally. The final form of the solution function of the physical-mathematical problem was shown to be acceptable for performing further engineering and research calculations. Originality. The functional connection of the measured values of the induced surface current and the parameters of the measuring system is determined, the experimental confirmation of which indicates the satisfactory calculation model of the induction heating system and the entire solution as a whole. Practical value. Based on the calculations performed, working samples of inductive systems for induction heating that meet the specified heating rate and area requirements can be constructed. The obtained analytical expressions were transformed and simplified for their further using for engineering calculations with a minimum error value.
Authors and Affiliations
Yu. V. Batygin, E. A. Chaplygin, O. S. Sabokar, V. A. Strelnikova
Keywords
Related Articles
- EP ID EP485184
- DOI 10.20998/2074-272X.2018.1.08
- Views 88
- Downloads 0
CALCULATION OF THE EQUIVALENT ELECTRICAL PARAMETERS OF THE INDUCTOR OF INDUCTION CHANNEL FURNACE WITH DEFECTS IN ITS LINING
Aim. The aim of the paper is to determine a quantitative relationship between measured impedance of the inductor and the electrical characteristics of the separated melt circuit parts for the determination of the place o...
MODIFICATIONS OF DIODE RECTIFIER CIRCUITS FOR CONTINUOUS INSULATION MEASUREMENT IN LIVE AC IT NETWORKS
Purpose. In the paper there are described few systems of insulation resistance continuous measurement using an imposed DC test signal delivered by diode rectifiers. Drawbacks of this technique are pointed out and ways of...
MULTIPHASE WINDING HOMOLOGOUS SERIES SYNTHESIS AND HARMONIC ANALYSIS
Multiphase windings are shown to form three types of homology. A bipolar winding homology formation algorithm is developed. Change in electromagnetic properties of the windings forming a homologous series proves to uniqu...
STATISTICAL PROCEDURES FOR TWO-SIDED LIMIT OF A CONTROLLED PARAMETER IN THE PROCESS OF PRODUCTION OF CABLE AND WIRE PRODUCTS
Purpose. To consider issues of statistical control in the process of mass production of cable and wire products on the example of enameled wire. To analyze the results of direct control of the diameter of the wire in two...
ON THE NEED TO INCREASE THE RELIABILITY OF LINEAR INSULATORS FOR DISTRIBUTION NETWORKS 10-20 KV
Introduction. In Ukraine high voltage overhead distribution lines (OL) of class 6 and 10 kV are the most extended. Their total length exceeds 280,000 km. More than 95 % of the lines are made on line supports from reinfor...