ANALYSIS OF FRACTURE OF THIN CERAMIC AND CARBON COATINGS BY MODELING AND INDENTATION EXPERIMENTS
Journal Title: Tribologia - Year 2011, Vol 239, Issue 5
Abstract
In article consideration about deformations and failure of coating-substrate system by plastic deformation of substrate and coatings fracture were presented. Analysis were based on FEM modelling and spherical microindentation results. Such complex analysis allow to determine critical loads and corresponding stress distribution leading to coatings fracture. Ceramic TiN and carbon a-C:H coatings deposited on X10CrNi 18-8 steel substrates were under consideration. It was found that tensile stress on the coatings surfaces, caused formation of first annular cracks, is sR = 6.5 i 2.4 GPa for TiN and a-C:H coatings respectively. SEM and TEM microscopic investigations have shown great impact of coating microstructure on trough thickness crack propagation.
Authors and Affiliations
Marcin Kot, Wiesław Rakowski, Łukasz Major, Paulina Indyka
Metody badań łożysk tocznych w aspekcie współczesnych wymagań wyrobów o wyższych parametrach eksploatacyjnych
Rozwój konstrukcji urządzeń mechanicznych wymusza intensywny postęp w produkcji łożysk tocznych. Kryteria, jakie muszą spełniać łożyska narzucają konieczność oferowania produktów dedykowanych dla konkretnych aplikacji. W...
THE INFLUENCE OF LOCATION OF THE SURFACE OF LOAD ON THE VALUE OF PRELOAD IN THE SYSTEM OF ANGULAR CONTACT BALL BEARINGS
Angular contact ball bearings are commonly used when high stiffness of the bearing is needed. However, a significant stiffness increase can be achieved only through introducing preload (mounting tightness) to the system...
Badania struktury geometrycznej powierzchni ceramicznych elementów trących endoprotezy stawu biodrowego
OPTIMIZING DEPOSITION PARAMETERS OF AlCrTiN COATINGS FOR IMPROVING THE WEAR RESISTANCE AT ELEVATED TEMPERATURES
This article presents the investigation performed to develop process parameters to produce AlCrTiN coatings with improved mechanical properties and the best wear resistance using the cathodic arc evaporation technique. T...
Wykorzystanie pracy adhezji i składowych swobodnej energii powierzchniowej do tribologicznej analizy stanu warstwy wierzchniej
W pracy przedstawiono tribologicznego aspekty wykorzystania stanu energetycznego warstwy wierzchniej do opisu właściwości systemu tribologicznego. Dla przykładu dokonano oceny stanu energetycznego warstwy wierzchniej sta...