ANALYSIS OF STRESS IN STEEL AND CONCRETE IN CFST PUSH-OUT TEST SAMPLES
Journal Title: Civil and Environmental Engineering Reports - Year 2017, Vol 3, Issue 26
Abstract
The paper presents the analysis of stress in steel and concrete in CFST composite elements subjected to push-out tests. Two analytical models of stress distribution are presented. The bond at the interface between steel and concrete in the initial phase of the push-out test is provided by the adhesion. Until the force reach a certain value, the slip between both materials does not occur or it is negligibly small, what ensures full composite action of the specimen. In the first analytical model the full bond between both materials was assumed. This model allows to estimate value of the force for which the local loss of adhesion in given cross section begins. In the second model it was assumed that the bond stress distribution is constant along the shear transfer length of the specimen. Based on that the formulas for triangle distribution of stress in steel and concrete for the maximum push-out force were derived and compared with the experimental results. Both models can be used to better understand the mechanisms of interaction between steel and concrete in composite steel-concrete columns.
Authors and Affiliations
Bartosz GRZESZYKOWSKI, Magdalena SZADKOWSKA, Elżbieta SZMIGIERA
Keywords
Related Articles
- EP ID EP243192
- DOI -
- Views 70
- Downloads 0
Emission and dispersion of gaseous pollution from exhaust shafts of copper mine
The primary objective of the study was to determine the volumes of emission and dispersion of gaseous pollution from 3 exhaust shafts of a copper mine P-VII, SW-3 and SG-2. To calculate the volumes of emission and disper...
TEST OF IMPACT OF VIBRATIONS FREQUENCY ON MEAN ERRORS OF THE PRECISE HEIGHT DIFFERENCES MEASUREMENT WITH ANALOGUE AUTOMATIC LEVELLER NI002
The article describes the results of tests carried out to determine the measurable effect of vibrations on the accuracy of measurements with an automatic precise leveller. It contains specification of the research statio...
Comparison of the calculation results of heat exchange between a single-family building and the ground obtained with the quasi-stationary and 3-d transient models. Part 1: continuous heating mode
The paper provides comparative results of calculations of heat exchange between ground and typical residential buildings using simplified (quasi-stationary) and more accurate (transient, three-dimensional) methods. Such...
Composition of a plan of an architectural complex
It may be proved that the space should be composed in a certain and not other manner for specific needs and objectives so that its form was not accidental. The composition is a very important part of creation - the knowl...
ENERGY-EFFICIENT SHAPING OF CONTEMPORARY BUILDINGS AND THEIR SURROUNDINGS AS AN ESSENTIAL ELEMENT OF MODERNIZATION OF BUILT-UP AREAS
A comprehensive design of a building along with the development of a surrounding land may counterbalance the tendency of housing estates comprising houses built on the basis of “ready-made projects” - which have no refer...