Analysis of the preform blowing stage when obtaining a polymeric product using the extrusion blow molding method
Journal Title: Восточно-Европейский журнал передовых технологий - Year 2018, Vol 2, Issue 1
Abstract
<p>It was shown that the process of blowing a polymer preform has two characteristic stages. We obtained analytical dependences that link geometric parameters (diameter, wall thickness) of a molded polymeric preform and parameters of the finished molded product to technological parameters of the process of extrusion blow molding of a polymeric product (tangential drawing rate, polymer melt viscosity, internal blowing pressure, tangential drawing factor, molding time). The illustrations of modeling different technological modes are presented. Basic calculations were carried out for the modes of internal blowing pressure from 1 kPa to 3 kPa for a polymeric preform made of high density polyethylene at a temperature of 200 °С, with effective viscosity 8,300 Pa·s, an average diameter of a polymeric preform of 0.05 m, and a thickness of its wall of 5·10<sup>–3</sup> m. In this case, stage 1 is characterized by moderate modes of deformation and is limited to tangential drawing factor k=2.5. Stage 2 has an intensive character of deformation, which can lead to defects of the molded product. It was shown that one of the ways for preventing defects is to reduce internal pressure when blowing a polymeric preform. In this case, the main factor that limits the rate of blowing a polymeric preform due to an increase in internal blowing pressure is the maximal dimensional diameter of the molded product.</p>
Authors and Affiliations
Dmytro Sidorov, Elena Kolosova, Aleksandr Kolosov, Tatiana Shabliy
Keywords
Related Articles
- EP ID EP527842
- DOI 10.15587/1729-4061.2018.126015
- Views 78
- Downloads 0
Development of the unified model for identification of composition of products from incineration, gasification, and slow pyrolysis
<p>This paper considers the processes of incineration, gasification, and slow pyrolysis. The common approach implies the use of individual models for the description of separate processes. When parameters acquire the val...
Research into efficiency of pasterization of boiled sausage products in order to improve their storage term
<p class="a">We present a study into bacteriostatic effects achieved by repasteurization at a temperature of 85–90 °C for 20 minutes in the presence of an oxygen absorber. The applied treatment method makes it possible,...
Development of calculation schemes for the combined extrusion to predict the shape formation of axisymmetric parts with a flange
<p>We have developed calculation schemes for the process of combined radial-reverse extrusion of parts with a flange. Based on the energy method, we have derived formulae for calculating the reduced pressure of deformati...
Development of energy-saving technology for maintaining the functioning of heat pump power supply
<p class="a">An integrated system of maintaining functioning of heat pump power supply based on prediction of a change of local water temperature was developed. A change in refrigerant vapor flow rate, the number of rota...
Development of technology of superconducting multilevel wiring in speed GaAs structures of LSI/VLSI
<p class="Abstract">Technological aspects of the use of superconducting materials are considered and the possibility of making targets for magnetron deposition of films for the formation of cryoconductive wiring in GaAs-...