ANALYSIS OF THE STRUCTURE AND TRIBOLOGICAL PROPERTIES OF SINTERED STAINLESS STEELS
Journal Title: Tribologia - Year 2017, Vol 272, Issue 2
Abstract
Increasing development of civilization encourages the search for modern engineering materials. At present, very interesting and promising materials are sintered stainless steels that are considered to be the most rapidly developing group of materials, which is related to the demand for materials with good mechanical properties and high resistance to corrosive agents. Taking into account sintered austenitic–ferritic steels, it is possible to obtain a structure with different proportions of the two basic structural components. The main problem limiting the applicability of sintered stainless steels is porosity, which deteriorates not only the strength properties but also the usability as compared to their cast and materials after plastic working. Extremely valuable factors influencing tribological properties are the chemical composition, proportion of individual powders and sintering conditions. In this study, the microstructure and tribological properties of sintered stainless steels obtained by sintering in different proportions of 316L austenitic steel and 409L ferritic steel were compared. The abrasion wear resistance test for individual sintered steels was performed by pin-on-disc method.
Authors and Affiliations
Barbara LISIECKA, Agata DUDEK, Katarzyna STRZELCZAK
Keywords
Related Articles
- EP ID EP239702
- DOI -
- Views 81
- Downloads 0
THE INFLUENCE OF TEMPERATURE ON COEFFICIENT OF MAGNETIC SUSCEPTIBILITY χ OF FERRO-OILS WITH DIFFERENT CONCENTRATIONS OF MAGNETIC PARTICLES
In this paper, the authors presented research concerning the determination of the relation between magnetic susceptibility coefficient χ of ferro-oil and temperature changes. The tests were conducted on the ferro-oil sam...
FORMATION OF PHYSICAL INTERACTIONS IN POLYMER-STEEL FRICTION PAIRS
This article presents the results of tribological studies of metal-polymer pairs by taking into account a wide range of the externally applied parameters of friction pairs (pressure, rubbing speed), reaching the limits o...
RELATION BETWEEN SHEAR STRESS AND SHEARING TIME IN SELECTED LUBRICANT COMPOSITIONS
The paper presents the results of studies of the influence of fillers introduced into lubricating greases on changes in values of shear stresses in resulting lubricant compositions. These fillers were powders of graphite...
Właściwości mechaniczne mieszanin polimerowych o przenikających się sieciach przestrzennych
W prezentowanej pracy przedstawiono wyniki badań nad modyfikacją żywicy epoksydowej przez dodatek zsyntezowanych poliuretanów, które będą mogły być zastosowane jako matryce polimerowe w nanokompozytach. Poliuretany (PUR...
THE ANALYZE OF FRICTION CONDITIONS ON A RAKE FACE WHEN FINISH TURNING ON THE BASE OF CHIP THICKNESS CHANGES
In the paper, the results of the analysis of theoretical equations to calculate middle coefficients of friction on a tool rake face during finish cutting are described. Equations viewed were compared with experimental re...