ANALYZING THE EFFECT OF HEATED WALL SURFACE TEMPERATURES COMBUSTION CHAMBER DEPOSIT FORMATION
Journal Title: Journal of Mechanical Engineering Research & Developments (JMERD) - Year 2018, Vol 41, Issue 4
Abstract
One of the most important studies on using diesel fuel is the basic study of combustion chamber deposits in engines. These studies were conducted to investigate the effects of deposits on the engine and how deposits are formed in engines. Deposits in the combustion chamber are proven to be formed through three different stages: (1) the condensation of components in incomplete combustion process on the combustion chamber walls; (2) the interaction of unburned fuel droplets; (3) fuel flow (intake valve and nozzle). This paper aim is establishing a correlation between deposits formation on the wall surface when fuel droplets interact with heated wall surfaces and surface temperatures. The changes of heated surface temperature impacted on the interaction of fuel elements with the surface, the evaporation and the dryness or wetness of fuel. In addition, in this study, zones of temperature with greater or lesser deposition formation were also identified. This helps to clarify the complex fluctuations in the deposits combustion chamber in real diesel engines.
Authors and Affiliations
Van Viet Pham
Keywords
Related Articles
- EP ID EP434706
- DOI 10.26480/jmerd.04.2018.17.21
- Views 77
- Downloads 0
THE IMPACT OF ALGORITHMS OF FORMING SWITCHING FUNCTIONS OF THE CONTROL SYSTEM IN MATRIX FREQUENCY CONVERTER ON OUTPUT VOLTAGE THD
The AC electric drive based on induction motors is the key basis for many technical rotation and translation systems. However, it requires a significant amount of electric power. In this regard, its energy efficiency is...
A STUDY ON THE FACTORS AFFECTING THE FLARE OF THE WELD WHEN WELDING THE STEEL WIRE
In this study, an equation for adjusting the parameters affecting the flare of the weld on the welding product was established. Based on the empirical research results, the factors affecting welding flux after using bend...
EXPLORATORY INVESTIGATION OF VIBRATIONAL CHARACTERISTICS OF THE UN- DAMPED AND DAMPED SPRING MASS SYSTEMS
The essential goal of this investigation was to break down the free oscillatory motion of dynamic systems and the powers related with the motion. This is the investigation of a free vibration of two states of a spring ma...
DESIGN AND FABRICATION OF DISTILLATION EQUIPMENT OF FRESH WATER FROM THE SEAWATER BY THE USE OF THE WASTE HEAT FROM DIESEL ENGINES
Although freshwater distilled from poor seawater, the amount of impurities is very small, does not meet the needs of the human body but is very good for machinery (such as cooling for machinery , equipment used for boile...
COMPUTATIONAL STUDY OF FLOW CHARACTERISTICS OVER HIGH LIFT AIRFOIL AT VARIOUS ANGLES OF ATTACK
A numerical simulation aiming to study and investigate flow behavior over a high lift low speed airfoil type AG-16 at various angles of attack ranging from 0 degree to 15 degree and constant Reynolds number “39,709” was...