APPLICATION OF DIGITAL DITHER TO REDUCTION OF FEEDBACK D/A CONVERTERS INFLUENCE ON INTELLIGENT CYCLIC A/D CONVERTERS PERFORMANCE
Journal Title: Metrology and Measurement Systems - Year 2006, Vol 13, Issue 4
Abstract
The effect of termination of resolution growth, common for cyclic analogue-to-digital converters (CADCs) the, which appears after a definite (threshold) number of the conversion cycles, is investigated in the paper. The effect is caused by the finite resolution of the D/A converter (DAC) in the feedback chain. In an "intelligent" CADC (IC ADC, [1-6]), the growth of resolution can be restored by adding the digital dithering signal to the signal at the input of the feedback DAC. The dependence of the rate of restored growth of resolution on the distribution and amplitude of the dithering signal is investigated. The results of analysis are verified in advanced simulation experiments.
Authors and Affiliations
KONRAD JĘDRZEJEWSKI, ANATOLIY PLATONOV
Keywords
Related Articles
- EP ID EP118660
- DOI -
- Views 51
- Downloads 0
TWO-PARAMETER MEASUREMENTS AND SIGNAL CONDITIONING IN DOUBLE-CURRENT SUPPLY FOUR-TERMINAL RESISTANCE CIRCUITS
A new type of the four-terminal (4T) bridge circuit unconventionally supplied by current sources connected in parallel to opposite arms, named double current bridge (2J) is presented. It has two different outputs from bo...
REALIZATION OF ATOMIC SI SECOND DEFINITION IN THE CONTEXT OF UTC(PL) AND TA(PL)
In this paper, the problem of practical realization of atomic SI second definition is discussed from the metrological point of view. Special attention is devoted to the maintenance of UTC(PL) - Polish local physical real...
SIMPLE METHOD OF 3D ERROR COMPENSATION OF TRIGGERING PROBES ON COORDINATE MEASURING MACHINE
In this study an automatic, simple algorithm of systematic error corrections of a CMM touch triggering probe is proposed. The whole process does not exceed a standard calibration procedure done on coordinate machine befo...
THE INFLUENCE OF FITTING ALGORITHM AND SCANNING SPEED ON ROUNDNESS ERROR FOR 50 mm STANDARD RING MEASUREMENT USING CMM
Coordinate Measuring Machines (CMM) become one of the main requirements in precision engineering for advanced industries, troubleshooting and scientific facilities. CMM data analysis software can contribute significantly...
A METHOD OF IDENTIFICATION OF RTS COMPONENTS IN NOISE SIGNALS
Noise signals containing two components with different distribution of current values of the noise signal, i.e. a component with Gaussian distribution and a component with non-Gaussian distribution, were analyzed. The no...