Application of wear-resistant coating by electrospark alloying method using an eutectic electrode material
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2018, Vol 4, Issue 1
Abstract
Analysis of the literature database connected with the usage of an electro-spark alloying (ESA) for tool hardening has been carried out in the article. Necessity of developing a new tungstenless electrode materials with eutectic structure for improvement of an electro-spark alloying technologies has been proved. Therefore, the structure of a new eutectic Fe-Mn-C-B-Si-Cr-Li alloy system has been developed and manufacturing techniques of an alloying by a sintering method has been offered. The article presents the scientific data obtained on the modern equipment. Electronic spectroscopy – spectral analysis of an eutectic electrode alloy has been carried out by an electronic spectrometer of JAMP-10S model (JEOL). X-ray phase analysis of the alloy has been carried out on the "Dron-UM1".
Authors and Affiliations
Oleksiy Bilous, Bohdan Mahura
Keywords
Related Articles
- EP ID EP498026
- DOI 10.23939/ujmems2018.01.040
- Views 126
- Downloads 0
Investigation of Influence of the Train Motion Speed on the Process of the Rolling Stock Derailment in the Presence of Railway Track Oblique
The article is aimed to construct the plots of speed range change, at which the necessary and sufficient condition of wheel rolling onto the rail head is satisfied, on the basis of generally accepted methodologies of the...
Study of Surface Microstrains by Electron Speckle-Interferometry Methods
Despite the fact that speckle interferometry methods began to develop more than 30 years ago, they still remain a rather exotic laboratory tool that has not received wide practical application in tensometry measurements...
Application of Taguchi Method for Optimization of Continuous Drive Friction Welding Process Parameters
The objective of present study was to determine optimal conditions to achieve satisfactory friction welds between two dissimilar metals namely copper and carbon steel bars of same diameter. Three process parameters namel...
Mag-Welding of Repair Structures of Main Gas Pipelines
Investigations on the development of a basic technology of the shielded-gas mechanized arc welding of strengthening structural elements which are used in repair of main gas pipelines were carried out. It is shown that th...
Gears with Asymmetric Tooth Profiles and New Alternative Method of Their Manufacturing
The article presents a new gears cutting process – radial circular generating method and describes its multiple benefits for manufacturers of transmissions. The overall increase of efficiency is realized due to using a s...