Arsenic Oxidation Using UV-Activated Persulfate in Aqueous Solutions: Optimization Using Response Surface Methodology Based on Box-Bencken Design

Journal Title: Journal of Environmental Health and Sustainable Development - Year 2018, Vol 3, Issue 3

Abstract

Introduction: The use of arsenic contaminated water can cause a variety of adverse health effects in humans. Therefore, it is essential to seek out a method to remove arsenic more efficiently. This study examined the amount of arsenic oxidation by response surface methodology (RSM) based on Box-Bencken design. Materials and Methods: In this study, oxidizing arsenite to arsenate was performed by activation of persulfate with UV and the optimal conditions determined using the RSM based on Box-Bencken design to evaluate the effects of independent variables on the response (arsenite oxidation efficiency) performance and to predict the best response rate. In this study, the effects of different parameters such as pH (3-11), concentration of persulfate (4-14 mM), and initial concentration of arsenic (0.1-0.9 mg/l) on process efficiency were investigated. The number of tests in this study was 45, and the oxidation rate was measured using the UV visible spectrophotometer (DR 6000) and the molybdate colorimetric method. Results: Increasing the concentration of arsenic increased oxidation. However, with increasing pH, the oxidation rate decreased and the highest oxidation rate at all concentrations was observed at pH 3. The value higher than R2 (0.934) indicated that the oxidation of arsenic (v) could be determined by this model. Conclusion: Arsenite is a highly toxic metal that is difficult to remove by conventional treatment methods, but a pre-treatment phase can convert arsenite into arsenate and facilitate the removal process. In this study, the use of UV-activated persulfate increased the efficiency of arsenic oxidation to 96%.

Authors and Affiliations

Hajar Salehi, Mohammad Hassan Ehrampoush, Mohammad Hossien Salmani, Hossein Fallahzadeh, Ali Asghar Ebrahimi

Keywords

Related Articles

Phthalates as Emerging Pollutants in Water Environment: Control & Treatment Strategies

Emerging pollutants (EPs) refer compounds that have not previously have been detected in water or sewage or their concentrations aren’t detectable. Nonetheless, today they are detected in water and sewage. The EPs includ...

Apprise of Used Electrical and Electronic Equipment in Residential Houses of Citizens of Yazd City and Determination of Their Knowledge, Attitude and Practice Regarding Electronic and Electrical Waste Management

Introduction: The production of Waste Electrical and Electronic Equipment (WEEE) has grown rapidly in recent years. It is necessary to determine the amount of them for its effective management. The aim of this study was...

Evaluation of Iodine in Distributed Salts in Abarkouh City in 2017-2018

Introduction: Iodine deficiency and associated disorders, which lead to a wide range of clinical manifestations, have been raised as one of the health and nutritional problems in Iran. Therefore, this study was aimed to...

Evaluation of Point-of-Use Drinking Water Treatment Systems Efficiency in Reducing or Removing Physicochemical Parameters and Heavy Metals

Introduction: Nowadays, many people have bought and installed home water treatment devices (point-of-use drinking water treatment systems), as an essential measure, to improve their health. Materials and Methods: This cr...

Exposure Assessment of Total Mercury: A Probabilistic-Approach Study Based on Consumption of Canned Fish

Introduction: Exposure to mercury (Hg) by consumption of fish is a recent health concern. So, it is important to evaluate the health risks related to canned fish consumption. The purpose of this study was to investigate...

Download PDF file
  • EP ID EP371619
  • DOI -
  • Views 101
  • Downloads 0

How To Cite

Hajar Salehi, Mohammad Hassan Ehrampoush, Mohammad Hossien Salmani, Hossein Fallahzadeh, Ali Asghar Ebrahimi (2018). Arsenic Oxidation Using UV-Activated Persulfate in Aqueous Solutions: Optimization Using Response Surface Methodology Based on Box-Bencken Design. Journal of Environmental Health and Sustainable Development, 3(3), 557-566. https://europub.co.uk/articles/-A-371619