Assessment of Air Pollution and its Effects on Health of Workers of Steel Re-Rolling Mills in Hyderabad
Journal Title: Mehran University Research Journal of Engineering and Technology - Year 2016, Vol 35, Issue 2
Abstract
The SRRMs (Steel Re-Rolling Mills) are being releasing air pollutants in the environment. In order to evaluate their effect on the health of the workers, health and safety issues were analyzed by first measuring the concentrations of SO x (OIxides of Sulphur), NO x (Oxides of Nitrogen), CO (Carbon Monoxide) and O2 (Oxygen) produced in the three SRRMs located in SITE area Hyderabad. The mean concentration of SO x , NO x and CO were in the order of 0.35, 0.280, 6.333 ppm, respectively, whereas the mean concentration of O 2 was 203.53 thousand ppm. As per results, the concentration ofair pollutants, including SOx and NO x were significantly higher than to the NEQS (National Environmental Quality Standards) and NAAQS (National Ambient Air Quality Standards). The concentration ofCO was lower than to the NAAQS, but higher than to the NEQs, while the concentration of O2 was slightly lower than to the standard value. The workers who were exposed to these air pollutants are being suffering from chronic diseases related to breathing and allergies. Moreover, labour staff was lifting heavy loads manually, which causes them to muscular and joint problems. In all the SRRMs under study, the electrical and mechanical equipments were used without any safety. The MSDS were not displayed on the workstations, the housekeeping was inadequate and most of the workers were performing their jobs without personal protective equipment. In addition to these, the other serious issues related to the occupational health and safety were an unhygienic supply of water, higher noise level, placement of explosive cylinders in the open atmosphere and unavailability of the first aid facilities in the Mill premises.
Authors and Affiliations
Altaf Alam Noonari, Rasool Bux Mahar, Abdul Razaque Sahito
Keywords
Related Articles
- EP ID EP190188
- DOI -
- Views 107
- Downloads 0
Simulation Studies Relating to Rudder Roll Stabilization of a Container Ship Using Neural Networks
RRS (Rudder Roll Stabilization) of Ships is a difficult problem because of its associated non-linear dynamics, coupling effects and complex control requirements. This paper proposes a solution of this stabilization probl...
Cache Memory: An Analysis on Replacement Algorithms and Optimization Techniques
Caching strategies can improve the overall performance of a system by allowing the fast processor and slow memory to at a same pace. One important factor in caching is the replacement policy. Advancement in technology re...
Short Term Economic Emission Power Scheduling of Hydrothermal Energy Systems Using Improved Water Cycle Algorithm
Due to the increasing environmental concerns, the demand of clean and green energy and concern of atmospheric pollution is increasing. Hence, the power utilities are forced to limit their emissions within the prescribed...
C in CS1: Snags and Viable Solution
Programming is one of the career rewarding skills; however, learning programming skill is extremely hard and arduous as supported by several studies. The first programming language has an everlasting impact on the progra...
Comparative Study of White Layer Characteristics for Static and Rotating Workpiece during Electric Discharge Machining
EDMed (Electric Discharge Machined) surfaces are unique in their appearance and metallurgical characteristics, which depend on different parameter such as electric parameters, flushing method, and dielectric type. Conven...