Bending of Sawn Wood Products Obtained from Conventional Sawing and Parallel to Generatrix Sawing
Journal Title: Architecture and Engineering - Year 2016, Vol 1, Issue 1
Abstract
This paper considers bending of sawn wood products obtained from logs by conventional sawing and sawing parallel to generatrix. Issues related to strength and stiffness of sawn wood products sawn parallel to generatrix have not being studied yet, thus such issues are of practical and scientific interest. Earlier our investigation dealt with changes in tilting angle of wood fiber of sawn wood materials obtained from logs by conventional sawing and sawing parallel to log generatrix. This concept is used for generating of mathematical models describing changes in elasticity modulus across the wood plank width which enables to foresee the wood plank bending strength and stiffness. The proposed procedure allows for the evaluation of wood planks bending stresses occurred when various log sawing schemes were used. Wood planks bending value is calculated to cover the difference between stiffness of wood planks obtained at the implementation of both sawing schemes. The investigation results are not only of scientific interest, but are also of practical interest in terms of construction and fabrication of laminated wood structures, wood structural panels etc.
Authors and Affiliations
Vladimir Glukhikh, Olga Khrabrova
Keywords
Related Articles
- EP ID EP289568
- DOI 10.23968/2500-0055-2016-1-1-4-9
- Views 96
- Downloads 0
Assessment of actual power and electric power at construction sites
The article deals with issues connected with power supply of buildings and structures under construction. Due to nonlinear nature of electric power consumption at building industry enterprises, current and feeding voltag...
STRUCTURAL APPROACH FOR NUMERICAL INTERNAL STRAIN MODELLING OF CONGLOMERATE STRUCTURES
The paper defines the principles for structure-simulation modelling of conglomerate material properties by an example of cement compositions. The constitutive essence of the principles consists in generation of hierarchi...
REDUCTION IN TANGENTIAL FROST HEAVING FORCES BY THE PILE GEOMETRY CHANGE
The subject of research is shallow foundations in seasonally freezing soils. One of the main reasons of reaching by foundation structures limit states in the strength and position stability is such hazardous natural phen...
THE MATHEMATICAL MODEL OF DOME COVERING INDUSTRIAL FACILITY
A statically determinate flat truss models the industrial facility's arch. To derive dependence of structural deflection on the number of panels in a span, the Maxwell–Mohr equation, computer mathematics system Maple and...
Optimizing the service life of plant machinery and vehicles using information system for management of engineering status
The paper contains results of studies of changes in performance of plant machinery and vehicles during operation: non-failure operating time, costs, revenue, profit and cost efficiency. It is shown that decrease of non-f...