Causes of Ductility-dip Cracks Formation in IN52 and IN52 MSS Alloys during Fusion Welding
Journal Title: Український журнал із машинобудування і матеріалознавства - Year 2015, Vol 1, Issue 1
Abstract
The aim of the paper is to investigate one of the causes of ductility-dip cracks (DDC) formation. The main aim of this work is calculation of grain boundaries (GB) cohesive energy in nickel based In52 and In52 MSS alloys. For measuring the GB energy anisotropy methods of thermal etching and light interferometry were used. DDC form on the grain boundaries of nickel based alloys due to adsorption of impurities during multipass welding. The In52 alloy has tendency to form DDC during multipass welding fusion unlike In52 MSS one doped with Mo and Nb. The main cause is the change of thermodynamic state of the GB, as it is indicated by the decrease in the cohesive energy to 1.8-1.26 J/m2. During multipass fusion welding in In52 alloy adsorption of S and O from the grains body to GB takes place. The average concentration of O and S on the surface of DDC for high angle boundaries is within 2.3-4.5 and 0.5-1 at. %, respectively. Presented in this paper results have shown the influence of welding heat for reduce the cohesive strength of GB and, as a result, of the formation of DDC. Quantitative effect of S and O as embrittlement elements on the value of decrease in the cohesive energy was shown.
Authors and Affiliations
Grigorii Beliaiev, Ivan Volosatov, Mykola Kakhovskyi
Keywords
Related Articles
- EP ID EP200704
- DOI -
- Views 107
- Downloads 0
Asymptotic method in investigation of complex nonlinear oscillations of elastic bodies
The main provisions of the methodology of the study of complex oscillations of elastic bodies are outlined. Its main idea is as follows: a) on the basis of empirical studies, the change of the basic parameters of some fo...
Fundamentals of Creation of New Devices for Speed Change Management
The article deals with problem of speed change management in engineering, i.e., hoisting, building, road and land reclamation machines, cars and tractors, machine tools and other equipment. The review of the methods and...
Cylindrical control of holes of tube details manufactured by deforming broaching
This work is devoted to the issues of processing holes in different thickness of tubular billets great length deforming broaching. The urgency of this problem is substantiated. The results of studying the regularities of...
Semi-active vibration absorbers for the high-rise objects
To determine the optimal parameters of the dynamic vibration absorber (DVA), a complete multi-parameter model of the dynamics of machines and structures is required. A model with two degrees of freedom is unacceptable fo...
Regulation of the phase-structural composition and metastability of austenite by alloying elements and parameters of tempering for increase wear-resistance of Fe-Cr-Mn deposited steel
It is shown that under the influence of alloying (Cr, Mn, C, Si, Ti, N, V) during electric arc hardfacing with a flux cored wire, as well as technological tempering parameters at temperatures of 300...700°C, the phase-st...