Challenges Encountered in the Machining of Ti-6Al-4V from Titanium Alloys: Review
Journal Title: Gazi Üniversitesi Fen Bilimleri Dergisi Part C: Tasarım ve Teknoloji - Year 2018, Vol 6, Issue 1
Abstract
Titanium and its alloys are used as high engineering alloys in various industries such as aerospace, automotive, chemical-petrochemical and biomedical because they have excellent heat resistance, corrosion resistance, toughness, strength, high working temperature and low weight ratio. However, these alloys have low machinability. In the machining of titanium and its alloys, problems such as surface integrity and cutting tool wear are encountered. In this study, subjects such as cutting tools, wear mechanisms, cutting forces, surface roughness are examined in drilling, milling and turning of titanium and its alloys. In addition, the difficulties encountered in the machining of these alloys have been evaluated and the literature studies have been discussed as detail.
Authors and Affiliations
Yahya Hışman ÇELİK, Erol KILIÇKAP
Nano Particles and Nano Wires
This article presents the review of nanotechnology as well as the synthesis, structure, and the wide-ranging properties of nanoparticles and nanowires. It determines this technology and materials, and gives information a...
Material Design for Biodiesel by-product Glycerine Evaluation
In this study, transesterification of glycerol which is the byproduct of biodiesel with dimethyl carbonate (DMC) to glycerol carbonate was investigated. Solid basic catalyst which is 35% KOH loaded to alumina was synthes...
The Effect of Heat Treatments on Alloying of Pre-mixed Al + 4.5 wt. % Cu Powders
In this study, 4.5 wt. % Cu powder was added to Al powder and mixed for 45 minutes to produce premixed metal powders. Premixed powders were compacted by cold pressing at 20 MPa. After that these samples were pressed at 5...
A Comprehensive Study on the Sensing Characteristics of a Piezoresistive Tactile Sensor
At present, tactile sensor technology is the only solution to measure the pressure and contact area of two solid in normal contact. In this study, the sensing characteristics of a taxel inside a flexible tactile sensor w...
Scale Effect of İntak-Entrance Profile On An Air-Entraining Vortex
Scale Effect of İntak-Entrance Profile On An Air-Entraining Vortex