CHANGES OF SURFACE LAYER PROPERTIES IN GEAR TEETH AFTER SHOT PEENING
Journal Title: Tribologia - Year 2016, Vol 267, Issue 3
Abstract
Considering the phenomenon during teeth cooperation in a toothed gear and produced loads within the macro and micro areas of contact surface, one should be paying attention to the type and condition of the surface layer. Shot peening is often recommended, especially for gears particularly loaded in addition to hardening by heat treatment. Therefore, the study presents hardness changes in tooth surface layers after shot peening, when the surfaces had been previously carburized and quenched. The article presents hardness distribution over the depth of the teeth. Measurements were made on oblique polished and etched surface, which allows the identification of the microhardness near the outer surface and through the depth up to the core. Furthermore, based on data analysis obtained from X-ray diffraction, the amount of retained austenite was estimated and changes in the metallographic structure after shot peening were illustrated.<br/><br/>
Authors and Affiliations
Michał TAGOWSKI, Henryk CZARNECKI
CHARACTERISTICS OF OIL REGENERATION FOR LUBRICATED FRICTIONAL CONNECTIONS
During the lubrication of frictional connections, physical and chemical processes causing changes in the fundamental properties of oil, such as lubricity and viscosity, take place. Such changes are from mutual interactio...
WPŁYW DITIOFOSFORANÓW CYNKU NA TRIBOLOGICZNE WŁAŚCIWOŚCI STABILIZOWANEGO TLENKU CYRKONU CZĘŚĆ III. SMAROWANIE STYKU TARCIOWEGO
Właściwości smarowe di-n-alkiloditiofosforanów cynku (ZDTP), di(mono-n-nonylo-fenylo)ditio-fosforanu cynku (MAP) i di(di-nnonylofenylo) ditiofosforanu cyku (DAP) zależą od struktury cząsteczki dodatku i jego stężenia w r...
WEAR IN THE MICROSCALE OF CAST IRON PISTON RING/COMPOSITE CYLINDER LINER CONTACT
The paper presents an attempt to explain the mechanism of wear in a contact cast iron piston ring/composite cylinder liner analysed at a microscale by using of lamellar model of a pearlite. For calculation of local stres...
Wpływ adsorpcji i temperatury na właściwości tribologiczne kompozytowych powłok Ni-P-Al2O3
W artykule poddano analizie wpływ zjawiska adsorpcji i temperatury węzła tarcia na właściwości tribologiczne powłok kompozytowych. Powłoki metalowo-ceramiczne typu Ni-P-Al2O3 wytwarzano sposobem bezprądowym na elementach...
A FOUR-BALL MACHINE FOR TESTING ANTIWEAR, EXTREME-PRESSURE PROPERTIES, AND SURFACE FATIGUE LIFE WITH A POSSIBLILITY TO INCREASE THE LUBRICANT TEMPERATURE
The authors present a new four-ball machine developed within the scope of the Multi-Year Programme PW-004 Development of innovative systems of manufacturing and maintenance 20042008, coordinated by the Institute for S...